My Whirlpool gold double oven displays the code F2E3 on the electric panel This problem occurs when I attempt to set the oven to bake. It is now a permanent display

what is the model #? sounds like a fused relay on the control board, or an element that is grounded to the frame. call a tech on this one, 240V appliances are not to be trifled with!

that's a bad touch panel or key panel,the number you sent isn't the full model number off of the oven so when you call to order the part you will need that.if you try to fix this yourself make sure the power is off.good luck

http://whirlpool.custhelp.com/app/chat/chat_launch will give you a chat line where the Whirlpool expert will chat with you and help you get your problem solved

your fuse is bad replace fuse.

I was just looking over a manual for a late model double oven. Their is a thermal limit going into the controls that will open if the temp rises enough to harm the controls. They look like this one. That kills all power to the control and you will see nothing on the display.

This manual will give an idea where to look:

Late model double oven

Helpful?

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

take the trim peices off. take the screws that hold it to the wall out slidee unit out a little to remove the 2 screws from the consol lift the consol up and off. make sure that you have turned the power off inside the unit you will see a tech sheet that will tell you what that error code means. let me know how it goes the tech sheet is usually on the left side.

I suspect a poor connection at the wiring to the EOC is the cause of the failures.

Usually this is a touchpad and control panel fault but the only way to know for sure is to do some electrical testing with a volt/ohm meter and the wiring diagram located within the appliance.

With the model number of the oven we could look up the code and be more specific about the problem.


Go here for: http://www.repairclinic.com/Whirlpool-Range-Stove-Oven-Parts

RepairClinic.com


appliance parts, help & more

Good Morning!
An E6-F2 is a very common control board failure. The control board in your appliance will need to be repaired or replaced.

Read more below about common Whirlpool oven Fault codes and what they mean.
GBD RBD Whirlpool Oven Problems Causes and Solutions 8302319 Whirlpool ELECTRONIC OVEN CONTROL CIRCUIT BOARD EOC

For some reason I get the same error code every time we have a power outage. If you push and hold the "lower off" button for about ten or 15 seconds it will unlock and reset. Hope this helps.