Dolce gusto my dolce gusto does not give any water, just heating and no caffe. I put water in and capsules and it does not wark.

If your Nescafe Dolce Gusto Mini Me is leaking milk from the bottom, there may be a few possible causes:

1. Check the milk capsule: Make sure that the milk capsule is inserted properly and is not damaged. If the capsule is damaged, it may cause leakage.
2. Check the milk frother: If the milk frother is clogged or not working properly, it may cause the milk to leak from the bottom. Try cleaning the frother and see if the problem persists.
3. Check the machine: Check the machine for any cracks or damages that may cause the milk to leak. Also, make sure that the water tank and drip tray are properly in place.
4. Contact customer support: If none of the above solutions work, contact the Nescafe Dolce Gusto customer support for assistance.

In any case, make sure to clean up any spilled milk thoroughly to avoid any safety hazards.

you can only remove the capsule from the capsule holder by means of piercing from under were coffee normally comes out .that is not to say that if the Circolo is not auto.
if the machine is auto then it may be that the director motor or gear of director motor is slipt or broken

Yahoo Web Search This should help you but you have a ad you need to listen to as well. Thank you and please leave feedback.

one step at a time do you get water with out putting the capsule
what is it doing is there any sound coming from the pump do you have any flashing red light? need more info

Same problem here!!

remove the plate which is clipped neat the capsule holder and try again if it works see if you can opening the hole or replace

In my case it was a minor detail: The capsule holder tray has a small magnet on the top right side, you can feel a light pull when you are inserting it in the machine. This magnet became dislodged from the capsule holder, and the machine won't operate and will give you a continuous blinking red light if the magnet is not in place; I found it when emptying a small bin where I put the used capsules. You just have to put it back in place with two drops of glue, or if you can't find it, just order a new capsule holder.

The picture shows the underside of the capsule holder and the magnet next to the slot it came from.

Have you used the pin to clean the needle? It is located behind the water container. It may also then need a coffee machine cleaner to be run through it. Don't use cleaners for dishwashers or washing machines, as these don't look after the internal seals so we'll.

We have had this problem twice now. The solution is to drill (yes drill!) through the capsule - a blocked outlet from the capsule itself and the injection of hot water creates a high pressure seal - you have to release the pressure. Do this over the sink - I had hot chocolate spraying about 6 feet from the machine when the pressure was released!! But this solved the problem.

use a solution of Bicarbonate of soda to clean scale from delivery pipe 1 tsp in 200ml

Please rate my help++++Thanks for using FIXYA