Printer error - see your documentation and call service if necessary

If the device is not functioning properly or to clear memory, reset it. Important: If resetting the printer's power does not clear the error or return the machine to a functioning state, it may be necessary to attempt a service reset. for instructions to attempt a service reset.

1. On the operator panel, press and hold the <ON/OFF> button for one second. (The display will go blank.)
   
   Note: It may be necessary to unplug the power cord if pressing the ON/OFF button does not shut off the printer.
   
   
2. Wait approximately ten seconds and then press the <ON/OFF> button again.
   
   
3. Wait until the device has completed its cycling process before submitting another job request.

Service Reset:

1. On the operator panel, press and hold the <ON/OFF> button for one second to power off the printer. (The display will go blank.)
   
   Note: It may be necessary to unplug the power cord if pressing the ON/OFF button does not shut off the printer.
   
   
2. Confirm the printer is not on and then unplug the power cord from the back of the printer.
   If the power cord was disconnected (as stated in step 1) in order to shut off the printer, go to step 3.
   
   
3. Press the <ON/OFF> button repeatedly five times.
   
   
4. Re-connect the power cord.
   
   
5. Press the <ON/OFF> button to power the printer back on.
   
   
6. Wait until the device has completed its cycling process before submitting another job request.

Solution:2 Load documents properly into the MX310 document feeder

Load the documents properly into the Automatic Document Feeder (ADF) Fan the documents and then align the edges before loading them into ADF.

1. Remove all documents from the ADF.
   
   
2. Fan out the sheets of paper well so that they do not stick together.
   
   
3. Stack the documents on a flat surface to align the edges of the paper.
   
4. Insert the top of the document, face up, into the ADF until a beep is heard.
   
   

Ensure that the edge of the document stack is in line with the Paper Size Mark (A) imprinted on the Document Tray.

i hve printer spooler problem

This means see the document you are printing or install it again

this means your printer waste pads are full and the printer needs to be reset for it to work again or it can just be reset

Reset the printer (power off and on). If still a problem, it's most likely a hardware issue and will need service.

Counter reach its preconfigured limit it is just, you have to reset the counter back to zero count. This feature could be attributed not to overflow the waste bin.

In your web browser search bar, key in " epson reset software" the uppermost link is the one. Read the tutorial before doing so.

Hope you get it easily.

pull the plug and unplug it again..or load and unload your cartridge..,or change the cartridge you using...maybe the printer don't recognize the printhead..

follow the link for downloads, faqs,troubleshooting, documents and manuals.
http://www.epson.com/cgi-bin/Store/support/supDetail.jsp?oid=41664
Mark

Link to documentation and manuals:

http://www.epson.com/cgi-bin/Store/support/supDetail.jsp?BV_UseBVCookie=yes&oid=25723&infoType=Overview

Does the printer print? and does the scanner scan?