Error req 0001002d

Sadly this is a serious error requiring a replacement Laser Unit - if you are lucky. It may also be a system board error that is falsely reporting the error.

This printer is likely to be beyond economical repair.

1 red blink every 2.5 seconds indicates a cover error-- for this check the lamp cover
2 times red blinks very 2 seconds indicates temperature error. for this let the projector cool off check filters and fans that there is no blockage of air for proper cool down
3 red blinks every every 2 seconds Power error. incorrect voltage input or internal malfunction.
4 red blinks every 2 seconds indicates Fan Error check the fans make sure they are working and not blocked or need replacing.
i have nothing on 6 ligths go ahead reconect and check for proper count. hope this information helps.
Best of Luck.

Ray.

Thank you for the inquiry.
This usually is a Epson Large Format printer error. You will need to replace parts to clear.


0001002D Cleaning unit EOL

Just like any other mechanical equipment, a printer requires attention to keep it running smoothly. So, just like when the check engine light illuminates on your cars dashboard so does your printer, but instead of a spanner the error 0001002D will appear on your control panel LCD which is informing you that a maintenance procedure is due to be performed. This will normally involve replacing the parts which keep the print head clean, hence the error "cleaning unit END OF LIFE" and the waste pads. This procedure can be undertaken here at Large Format Repairs for the Epson Stylus Pro 3800 right upto the beast that is the Stylus Pro 11880.
Worn flushing box Worn cap assembly Worn head wiper Worn carriage waste pad

this error 0001002D means Cleaning Unit end of life

The only fix for this problem is you have to call Epson and state them that you are facing this problem. They will provide you the codes to unlock this error. Its a universal solution that only Epson can provide you these unlock codes and you cant find in any websites.So contact them and get your problem fixed soon.

techbelkin

http://www.largeformatrepairs.co.uk/technical/maintenance-error-code-0001002d.htm
This happens when you let the "maintenance req. 0040" go for to long. The machine turns itself of to prevent damage.

Solution: Call epson and they will give you the reset code. Cannot find these codes online so if you do call please post instructions
Please rate the answer........

Check the lamp door it has to engaGE THE SWITCH OR IT GIVES YOU A 3 BLINK ERROR.

This is the result from running the machine with the maintenance code of 40 for too long (needs service parts replaced including pump cap assy and then reset counters). I have all you need (full maint manual, reset software and parts) if you need them. [email protected]

44 inch lg dlp hdtv no picture or sound press power button standby light turns yellow and then back to red

This happens when you let the "maintenance req. 0040" go for to long. The machine turns itself of to prevent damage.

Solution: Call epson and they will give you the reset code. Cannot find these codes online so if you do call please post instructions

The flashing red indicates that either the fileter cover or the lamp cover is not installed correctly. If both are installed properly and secured, the unit will require service.
Dan