Dishwasher Whirpool not finishing a cycle.

I couldn’t find any error code 2H but I did find an error code H2O. This code means insufficient water pressure. If the display reads 2H, it usually means the start delay function is turned on. The dishwasher will turn on in 2 hours if door is closed. This dishwasher is advanced. To understand all operations you should read the user guide or manual.

well..sounds like perhaps the control board is having a fit..unplug it first, let it discharge(usually around 4 min) and then have a go at it again. Does this occur on all cycles?

check the lock maybe it flipped shut lock maybe getting stiff from steam?

Try to feel the temperature of water inside the dishwasher. If it is normal room temperature for the hot wash cycles then it is likely the heater is faulty.
It is not easy to replace unless you have good experience with repairing dishwashers.

I am doing all this and nothing! No lights turn on briefly, no short cycle begins..nothing. It will work 1 cycle then not a cycle, I have reset with turning off breaker, using the key sequence above, thought it was a drain issue, replaced the hoses. And here we are machine is not even a year old yet. Help

I am curious what the repair guy found. We have the same problem.

If you wish to eliminate or reduce the volume of the end of cycle beep you can do so by powering off the unit and turning back on while holding the right button “Cancel/Reset”. The beep has 3 volumes levels and silent, press the right “Cancel/Reset” button to cycle through the settings. Power the unit back off to save you setting.

I have experienced this problem before and it turned out to be the main control board in the console. Not a cheap fix, either. The control boards are not serviceable, and can run over $100. Sorry, I hope I was of some help.

Raise temperature of your water supply. Open door and press hi-temp srub,then energy saver, then reapeat this within 3 seconds. Close door and hit cancell.