No stand for my 37'' westinghouse flat screen tv

Put tv on bed face down and look at the stand and locate and remove any and all screws holding stand to the flat screen set. Then after mounting the wall plate per instructions mount the tv to wall mounting.

By "sound but the screen on my westinghouse 32 inch flat screen is solid lime green" Do you mean that you have sound but the screen is green? If yes it means that an analog signal is being fed to a digital input. Did you recently change the input cables at the back from one port to another? If not then please describe what are colors of the cabels you are using(Yellow, Red, White or Red Blue Gren etc.,) and what port they are connected to so that I can tell you whether its a problem with the connections or the tv itself.

Ur tv the LCD inverter board it dead.The LCD inverter is the board that help the LCD screen panel to get a backlight to produce a picture,the LCD inverter board is dead and it not working anymore that why u only get 8 sec.of the picture.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish LCD inverter board for the replacement.It a long board in shape.

Ur power supply board is dead.Take ur tv aparts,replaced the power supply board.Ur tv will get ur power back an the tv will work again.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.

Hello, it sounds like you need to replace the inverter board on this unit. I would recommend opening the unit from the back cover, get the part # for the inverter board (long green board normally running accross the edge of the TV) and go to www.shopjimmy.com, they should have it in stock and if not you can try www.invertercentral.com, they should also have it.

It is likely that a circuit board might have cracked in the fall and/or a chip might have cracked. LCD's are more fragile than conventional CRT's.

you should try Ikea...they have everything :D

The cheapest I have found is Videosecu Dual Arm TV Wall Mount Bracket for Sony Bravia 32 37 40 42 46 50... on amazon. I hope this was helpful. regards

i had the same problem...but its simple...u need a Phillips screwdriver....on the back of the tv next to part that sticks out farther than the rest of the tv... there are 4 holes with phillip screws....u can almost make a rectangle out of it... take those screws out... then the tv stand slides right out.

Most likely you need to replace the lcd panel