I have a 936 Huskyloc Serger and have no instructions for threading it..... HELP!!!!!!!!!

Hello Susan.
All the different screen display adjustments are found starting on page 10 in the manual. If the manual is not readily available, here is a free link: Viking Huskylock 936 User Manual Sewing Advisor Display Function
The screen contrast is not adjustable on the Husqvarna 936 serger.
Happy stitching.
Sewingirl/

It may be difficult to solve a computer controlled machine with as many options as the 936 serger. Stepper motors control many of the functions. You can check out this video I made 4 years ago to get an idea of where to look.

try this link for parts and needles
http://www.sewingpartsonline.com/husqvarna-viking-936-sewing-machine-parts.aspx

Recommend you remove all the threads and rethread from the beginning. ALWAYS RAISE THE PRESSER FOOT when threading and thread the upper looper first, the lower looper second. Sergers sometimes are temperamental about threading. When in doubt, start over from the beginning.

http://www.sewingresourcesonline.com/product/PD1234

 

I have the same serger.  The produt link posted above is an awesome intrustional dvd on learning the cover stitch.

I could not find a manual for your machine, but did find this video - it starts a little silly, but the instructions are presented very well.

http://www.youtube.com/watch?v=VmayuqlJ31Y

Make sure you have completed all the steps to convert to cover stitch. There is a "clutch" to move from S to C for coverstitch that is located on the inside front of the machine where you thread the lower loopers. Make sure you have "locked down" the looper as instructed. There is a VHS and a DVD available from the Husqvarna Viking dealer. You can locate a dealer near you by visiting the husqvarna viking website and clicking on the Dealer link on the left-hand side of the page - http://www.husqvarnaviking.com

Good luck.

Hello, The first thing to do with a serger is to change the needles and take the thread off the machine and rethread it. The 936 can sometimes "fight" you a little when it comes to getting the needles up in all the way. It's critical that they are inserted all the way up in the needle clamp. Check to also make sure the N/R lever is in the N position. Check the needle plate, are the "needle like" pins still attached to the plate? If your serger jammed, sometimes the thread breaks the pin supports out of the plate. They are very important when it comes to stitch formation.

This link will give you a video of your machine to watch, it's awesome!
http://www.husqvarnaviking.com/mediafiles/huskylock/index_en.html