TV CODE Hi Friend i need information for the code and reset the code for the TV, because i introducing other code for error and i don´t remember please help me. Thanks

Hi,
please elaborate :
- how was it connected to Telus ?
- why do you need an Apple code ?

Hi friend, thank you for your inquiry!

On an Electrolux washer the error code "E00" stands for No code stored. This could be a miscommunication I would recommend you perform a reset on your washer. You can do this by flipping the household breaker for roughly ten minutes. If resetting the power does not correct the issue, could you please inform me of the new error code or if your washer continues to display "E00". I look forward to assisting you. -Matt

Hi did you by any chance find out the code to reset ur tv?? Im having same problem.

Hey friend if you want to restore you phone,you have to use this code without simcard*2767*3855#
100% sure ur phone reset n work well :D
don't fash .. Be hapy with samsung :) And remember to vote me..!!!

It is showing SAFE because wrong codes have been entered previously

Leave the radio SWITCHED ON...UNDISTURBED for as long as it takes to automatically reset itself

It may take an hour or more

Hi,

You are not the first to complain about this today. This is a general problem at the moment,so don't fret.........

The error code as to do with a network/server problem.......

Usually, when PSN server is down, it makes this type of error to occur. I believe they are working on the servers.

There is no easy fix to this, you just have to wait for an unknown amount of time till the network server comes back again.

You can reset your network and try again. Or If you have a friend that uses PS, check if that of your friend has this same error...............

Regards.

Try with a full firmware restore using blackberry website

Hi fatboy,

Here is the Master reset code.

IMEI:359813011232959

Master reset code:0534127033

If it's helpful, plz do vote for me...

Hi, Victor955


This is a Processor Rest Error

This error code is displayed if the control failed to save cycle information during a power failure. This does not generate an error code beep.

Press STOP/CANCEL to clear the display.
And if needed unplug for 5 minutes to reset the system



Please remember to leave a rating.

Don t worry I have exctly the same problem y nobody have help me