I can't get my H3 headset to pair or even be recognized on my blackberry curve or my envy. What can i do? it still turns on.

When you pair a device, the passcode is typically set by you. If not, however, 0000 is a common passcode for motorola.
Hope this helps! Rate my solution!

Hold down round button on earbud for 5-6 seconds until the lights blink alternating red and blue.....then, enable your phone/device to connect in pairing mode. This will be a "find device" command or something similar. Once they recognize each other....it will send you a screen to enter a code. This will be 0000.....enter that...and once they pair...you are good to go.

0000

on the soyo freestyle 600 you have to power on the device (hold power for about 5 sec) then hold either the volume up or volume down button, I forget, for another 5 sec it should go into pairing mode (Blue-->Red flashing) youre blackberry should b in search mode for bluetooth devices at this point. Then youre blackberry will recognize the device and ask for a passkey (0000 default) registration will be complete at this point once the blackberry recognizes the headset..

How to pair a Motorola HS850 bluetooth headset How to place a Motorola HS 850 bluetooth headset into paring mode:

1. Close the boom to turn the unit off.
2. Hold down the call button until the blue light comes on.
3. While holding down the call button, swing the boom open.

The headset is now in pairing mode, and you can search for it using your phone. When it asks for a PIN, use 0000.

On the Blackberry, Go to Options, Bluetooth. Select the blackberry button, Add Device, and search. If search doesn work, try listen. While these are going conduct the following on the Headset:


Close theheadset. Go to the phone and choose discover, or search. Open theheadsetand pressand hold the big button. It should then turn purple and should be recognized.

Also make sure thebatteryon theheadset is charged before doing this.


If this doesntwork: Start the search onthe phone, Keep the boom of the mic closed when you press and hold the buttonon the h700. the light should turn purple. After this, open the boom

try to delete it out of ur phone all the way and then try to pair it again

Power it off
Press the power on button for at least 10 seconds, until it keep the blue ligth on and then pair it with your BB

;)

http://khaoohs.wordpress.com/2007/11/16/motorola-h700-bluetooth-blackberry-pairing/

this actually works.

It might already have been figured out but if you hold the answer button on the headset down until the light stays on steady, it is in pairing mode. You can then go to bluetooth setup on the Curve and it will find the headset.