Machine wont take on water - Maytag Neptune MAH5500B Front Load Washer

The cold water solenoid valve went out. Be sure the cold water valve is turned wide open.

Hi,

If your washing machine will not fill, only hot or cold will fill or is slow tofill then read these tips. I have covered many of the things that can happen inthese tips...


Washing Machine Problems No Water

Washing Machine Fix Washing Machine No Water

heatman101


dhjd

Drain Vlve command no activated. Or The valve is faulty. Check wiring also.

sounds like your pump may be gone, or could be pipe blocked. to check pipe fill machine take outlet pipe at rear of machine and lay this into a bowl. If water flows ok then all pipes are clear. As water is coming through just put machine onto spin cycle and raise hose to see if water will then pump out.

It will not spin with water in.
See if you can locate a filter, and clean same.

there are a lot of questions of a simular nature check the diaphram switch this controls how much water is taken in and wont progress until the switch says so what you dont say is if the machine keeps filling or stops filling and wont progress

First : The machine will not spin with water in it. So you will half to start by checking the drain pump.

The water valve is what you will first need to check the cold water.

p my machine hotpoint ultima wma 60 wont empty water tried various times water sitting there had turn machine off

SOUNDS LIKE INLET VALVE IS PLUGGED. THIS SHOULD NEVER BE CLEANED ONLY REPLACED.

fill it with water start the machine when hot open side valve to let water out if it doesnt do the job remove water tank in the kit of the machine there a little pump put water in the pump in the water hole force water in there with side valve open let me no pierre