The color on my 52" is way off. Plugged it in after moving and I have lots of blue and red in the wrong places.

This is common, You have a convergence problem. The convergence IC chip replacement installed. They sell them on Ebay.

Resolder the connections on the hv transformer. there are 3 little boxes to the right of the transformer. replace the middle one. its a fuse. the value is 400ma.

your convergence output amps are done...
you have to do repair on the convergence output circuit, and inspect
the power supply for any damages.

Sounds like one of the cables got plugged in wrong.

Look at the back of the HD box and there should be a cable with 5 ends on it (Green,Blue,Red, White and Red).

Often times a flashlight can help make sure you see the colors clearly.

The Green,Blue and one of the Reds is for video. The White and other red are for Audio.

When you unplug the connector the connection it is attached to is also colored. Check to make sure the colors on the cord match the color they are connected to at the box.
The most common mistakes connecting these cables are:
1) Crossing the Green and the Blue cables.
2) Connecting the Red Audio cable to the Red Video connection.

If all of the connections match the correct colors find the same cable where it plugs into the back of the TV and check these connections that they are correct.

When you find and move the cable to the correct connection this should clear up your color and you can begin to enjoy your new toys....

Good Luck....

Red color gun has failed, which will make the picture over saturated with the other two colors(blue,green) the bad news is the three color guns need to be replace in a set(all at the same time) because if you only replace the red it will over saturate the older blue, green guns then your picture will be mostly red.Unfortunently in most cases it's not worth the investment, better off to purchase a new tv. Good luck !

Check to see if you are using componet cables which are video cables and make sure your red ble and green are in the proper places on the reciever and the tv.

the ITC222 convergence option missing repair kit at the following link will usually repair that. The kit has the parts and the CD with instructions
http://www.tvrepairworld.com/

My TVs are all old enough that they don't even have the adjustments you've tried. But one thing to look for. CRT televisions are vulnerable to magnets. Do you have any large speakers nearby? Magnets screw up CRT colours.

Not sure if you have the same problem I have but my colors are all off too.  I have a 52" projection and from calling RCA with my problem (colors off & have shadows) they said all projection tv's color need to be adjusted every so often (which they do not tell you) after purchasing this tv for $1000.00 13 mos ago I have the same problem.  It will be approx. 500.00 to fix the problem and I got no where with the RCA 800 number.  A friend of mine had the same problem so I am sure its the same.  Good Luck!

Call a technician, sounds like an Integrated Circuit problem and would cost you about $250.