Kenmore elite he4 quiet pak 9 dryer display code

You can check this site for parts, you will need o have skill, knowledge, and tools to repair dryer No one can tell what is wrong without inspecting item.
https://www.repairclinic.com/PartDetail/High-Limit-Thermostat/W11050897/4533962

Sounds like the belt that turns the drum could be broken. I'd check that first.

You are getting moisture in the control panel buttons. After a while the panel will not function at all. The light in the dryer tub will still come on when the door is open. When you unplug your machine and it sets for awhile you are allowing the moisture to dry and the machine can reset. Some people use a hair dryer to dry out the control panel for a temporary fix. Eventually, you will have to get it replaced once it stops resetting for you.

My Kenmore Elite dryer keeps beeping..just going through the end of cycle alarm-high,low,off...anyone have any suggestions?

Check that the slide/rod /bracket is not jammed on the adjusting mechanism.

m dryer did the same thing tonight and it was the door switch luckly i wiggled it and it came back on

Hello plz make sure the gas burner does not have any lint build up on burner assembly inside the machine / plz clean.That usually causes a burnt smell. If there is no error codes on the display and the machines is operating fine you are chasing a ghost. If there is a pump or motor over load an error code should come up on the display.

possible front control bd ..be sure there is 220 volts to rear connection first

Error message E1 indicates the temperature thermistor has failed.

Check your manual should have a basic code listing in the back......is it pumping all the water out??? That might be off base....but it is the most common on a late model front loader.