I have a Zanussi DX6453 dishwasher. Water will now not enter the dishwasher; the inlet is not blocked and I have tried rocking the unit back and forth. The wash LED flashes c ontinuously and the end LED flashes intermittently. Any help greatfully received. Mark.
Hello,
Try tipping the dishwasher back to see if any water drains out from below if there is water present then the anti-flood device is energised and stopping water coming into the unit.If it works now after resetting then there is a leak under the machine that needs investigating.You can try going into the diagnostics to read the alarms.If you hold in the first and third button from the left on programmer,whilst holding in then press the on/off button then when the lights start racing release these 2 buttons.You should now be in the diagnostics,now press the first button once and count the flashes of the end of cycle LED.If this button is pressed 2 more times it will give the previous alarms.1 flash could indicate fault on inlet water and valve.2 flashes drain circuit blocked.3 flashes anti-flood device.8 flashes faulty circuit board.Make sure after reading alarms to switch off unit then on then off to reset.Then go back into the diagnostics as before to reset alarms but this time press button 2 from left all LEDS will flash after exit as before.
Hope this helps.
We had water restrictions for a week and the water pressure was low during the day, now my dishwasher won't work.
972 views
Usually answered in minutes!
×