How to know IP adress for Canon ir c6800 - Canon imageRUNNER C6800 Copier

This is regular feature. Nothing defective here.

IP address is to communicate with the router on wire or wireless.

Dynamic IP address will assigned to your printer again when re-connected and will be lost when disconnected.
Static IP address assigned will be reserved at the router for the device even when the device is disconnected.

Click the Menu button on the printer and scroll to the Network settings to the IP address. You may need to change the IP address to suit your network.

the easiest way is to print out a function list on the copier it should give the ip address on the list then open internet browser and input the ip address in the browser nd change the ip address there dont forget to make the ip address static hope you come right

Hi,
do You want to connect the machine on network or .... ?

First check if you on back side of copier have the network connector.
If yes, you need to connect the normal network cable if you have network switch or cross cable if you are connect directly on PC.
Then you must enter the IP adress in machine, under user mode (*) under system settings, under IP adress.Also enter subnet and gateway adress.
Free IP adress you can check on your pc under CMD and type ipconfig, to see your ip, subnet, and gateway.Then type : ping XXX.XXX.XXX.YYY The YYY marks number that you can change and must not be same as yours PC.After typing ping .......... and you have answer DATA LOST that means the ip is awailable and you can type it in copier.
Install drivers and select tcp/ip port.

If these isnt solution that you asked for, you can also contact me on [email protected] with more detailed description.

Hope that helps!

you need to be able to configure your lap printing drivers to print to the ip adress of the copier.... does the copier have a rip or is it stand alone

On the control Panel
Press Additional Functions Key.
Press Report Settings
Print List should be 2 rows of choices/ Select Network and print list. TCP/IP will be on the print out.

To Change the IP Address
Press Additional Functions
Press System Settings
Press Network Settings
Select TCP/IP Settings
Enter New Address or turn DHCP on
Back out by using reset key on control Panel.
Be sure to re-Power the copier by turning off/on at the main power switch on the right side of machine or any setting will not take.

Probably because the scan2PDF is using twain drivers. The reason why you get an error message is because the ip settings that it needs in the device settings to scan via network is not configured correctly. That is why it times out because it cannot communicate without the ip adress

go to printer tab then function then print pages then configuration page. and you'll see the ip address

This printer does not have a network interface. There is no ip address for this printer. You must connect via usb.

i have an IR 3300 (used) i have given TCP/IP correct with machine and PC also. ping command is working properly and IR Machine also response from the host and also i'm success output (Printout) but can't scanning. I have scangear also tried but the messeage appear "the spacified IP address is invalid or scanner is not connected to the specified IP" but my IP address is correct. (both side) i know that after this my Machine will be online from System button but there is no software. i cant solve my problem
how can i connect my Machine from PC