I have the above mentioned washer/dryer and yesterday I was washing the dogs blanket and the washing machine stopped on the rinse/spin cycle (due to my 18 m/o pressing buttons as they do) and filled right up with water. Now the machine is detecting an upbalanced load and will not spin or pump out. Before I call out a repair man can anyone give any suggestions how I can get the water out of the machine without opening the door. Pls help xx
Hold the start button for 5 seconds this should clear previous program. then select drain on your dial. press start as normal and machine will drain. if this does not work the only other remedy is with help, making sure the end of the drain hose is higher than drum at all times take machine outside, lean it back at 45 degrees agaist a wall with a towel or similar covering lid to stop scratching . working from underneath loosen the large jubillee clip that connects the drum to pump drain hose to the drum. As the drum is overfull there is no recepticle large enough to fit under so just let water just flow away. Dry every thing off. make sure you don't loose ping pong ball in filter and make sure filter is clear. refitting is reverse of removal
SOURCE: Hotpoint Aquarius wd440 washer/dryer wont pump out water HELP!
Try unplugging the unit and plug it back in. This may reset the controls.
671 views
Usually answered in minutes!
×