Re: I need the wiring diagram for power,reset,lights
There is no need for the wiring diagram
if you check *********** board properly
you could find written in small font like
PWR SW for power switch
RST SW for rese switch
HDD LED , PWR LED etc
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Wiring diagram for a 3-way switch, one of the many wiring diagrams showing different methods of wiring a three way switch circuit. This electrical wiring diagram shows power into light switch Box #1 – wire to light from switch box #1, and from switch box #1 to three-way light switch box #2.
If this is the version with the motor under the dash and all electric then sorry its a dealer only job as special software is needed to reset the straight ahead position .Longer story than that but this is my last question as iam tired
Good luck on finding a wiring diagram. Usually those plugs represent the Power Button, the Hard Drive and the other sometimes represents a reset button. If you remove the cover and sit the computer on it's side, take a flashlight so you can see inside at the motherboard. If you look from where the wires come from on the front they usually stick into little prongs on the side of the motherboard. The motherboard will have little written identifiers such as hdd for the hard drive light, pwr for power or power reset, fan for fan, etc.
Also sometimes if you look on the little piece at the end of the red, white and black wires where it plugs into the motherboard prongs, sometimes it will have writing on it as to which one it is.
You can try an internet search for the wiring diagram. No power to all the parking lights? Then probably the light switch. Make sure you have power to both sides of the fuse. If not the either wiring from the switch or the switch itself. Good luck.
If i understand you correctly, you want to wire the box to the motherboard so that reset, power etc works?
Look closely on the board, there are small hints printed on it. eg...
pwr, reset, spkr etc. and on the colored wires, there ought to be
printed reset, power etc. just match them and plug them in. you can't
do too much damage if they are wrong.
I can email full diagram to your email address...just post it here. I can tell you that power wires are:
1.) memory power (all times) is light grn / violet 2.) power in start position is red / black 3.)power w/ acc. delay is pink 4.) ground is black / light green
×