E30 error message what does it mean, Cheers, Dave

Hi

The code meaning is below

E30: The size of the original cannot be correctly detected or the document is too small when the Fit-to-Page copying is selected

Cliff Cook
MCP

On a Logik L712WM13 E30 means there is something stuck in the door.

Good Morning Lauren, thank you for your post!

If you are receiving an error code E30, first check if it is a false error code by resetting the power to your appliance by either unplugging it or flipping off the breaker for about 30 seconds. If the error code persists and since your washer is leaking, it could potentially mean a number of things: a pressure sensor issue, defective wiring, valve assembly problem and/or control board issue. I am fairly confident that an authorized service agent will be able to restore your appliance to its normal operating condition. You can often locate a qualified service technician on the manufacturer website.

Thanks for allowing me the opportunity to assist you!

3 Beeps/E30--Error: Drum overfilled. Cause: Inlet valve,pressure switch or control board failure.Select drain/spin to remove water. Restart.

Hi John, thank you for your inquiry!

If you are receiving error code E30, first check if it is a false error code by resetting the power to the appliance by either unplugging it or flipping off the breaker for about ten minutes. If the error code persists, and based on the symptoms you are describing it could potentially mean a number of things: a pressure sensor issue, defective wiring, faulty pump, and valve assembly problem and/or control board issue. I would recommend reaching out to an experienced appliance tech just to ensure no troubleshooting step has been missed. Parts are often costly and if the problem is precisely diagnosed, it can save you a lot of time and funds. I hope these troubleshooting tips help you in some small way.

Thank you for allowing me to assist you in a small way.

E30 means the motor isn't working on this machine. There used to be a 7.5 amp fuse on the power modules on these micro processor controlled washing machines which used to blow if the motor went faulty.

It could be that the brushes have worn out and the motor has blown the fuse. This can happen if they spark excessively but it can also happen if the armature goes down to earth, or the armature is faulty. You really need to test the insulation of the motor though with a specialist meter (megger)

According to Canon's Knowledge Base here, this error means that there is a problem with the shutter. It appears that the camera needs service. If you just purchased the camera, it should be covered by warranty.

There are different types of Dell power adapters, some of them put out different amounts of power. While it is possible that the battery is faulty, it is more likely, given your error message that the adaptor is wrong. If you got it from Dell, you can call them and they will exchange it.
Cheers
Dave

What does the E40 error code mean?

Hi Chittu, This error usually happens when there's problem reading and writing from the Flash memory card (CF). Did you try to pull the memory card before the camera finished writing data? Here's what you should do - try using another memory card. If it works, it means that the original one is damaged. Let me know if this helped. Please rank this post.