"control locked" light is on, how do I restart the washer

Is the dryer 120 vac or it it 240 which is the standard power? did it just plug in the receptacle or was it changed.

Good morning friend, thank you for your post!

I understand that you are asking what the yellow light with a lock button on your Frigidaire washer means. Typically a lock symbol stands for control lock. I notice you did not provide your model number, if you comment back with your model number I would like to research to verify the information. Normally you can locate the serial tag (which lists your model number) on the upper front of the door frame on a front load washer. If you own a top load washer you would normally find the serial tag on the inside of the lid, on the right side. I look forward to your response.-Matt

Front loading washers have always been a pain from the first ones made by Westing house in the 1950s, now they have come back in style, and more complicated than ever, that means they are going to be expensive to repair. the pump went out on my son's in wisconsin ,$500 parts and labor, $100 more than a new no frills top loading washer costs new. we have had a Maytag top loader for 32 years and have replaced one belt.

hf is a water problem if after 30 seconds control doesn't detect water it will go into a error code

One hour service plus $40 part.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

too much suds in washer--
try using HE detergent-
reset to rinse cycle I think will work-been awhile since I had that code-
ready to throw my GHW 9150 off a cliff-FDL codes-door locks up.

HI, The Central Control Unit has failed. you will need to replace this failed control board asap.

We recommended a service call for this type of repair.

what shoul I need to fix when the light sensing on and the dryer does not start ( it still hot ) .
Whirlpool dryer GEW9200LW
reply to [email protected]
thanks

find button with lock emblem beside it hold down 3-5 secs

Press and hold the End of Cycle Signal button for three seconds. This will turn off the Control Lock feature.