Hi i have 2 freezers turned one of to clean

You only have 1 or 2 things to check.
1. Cold control off or not set to a temp. desired position
2. Compressor overload cutout on side of compressor.
If it's a self-defrosting unit, a timer, heater, thermal cutout could be an issue.
This site may help in diagnosis and carries parts

https://www.repairclinic.com/RepairHelp/Freezer-Repair-Help

I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

Wash it out with a mixture of 1 ounce ECO friendly bleach mixed in 1 quart of hot water.

put torch inside at night turn off lights if you see any light from inside seal is leaking.Adjust hinges to repair

Hi,

As the weather is getting warmer for many people their freezer and/or refrigerator do not work right because of a dirty condenser coil...

Check out this tip that I wrote about that... it is a great place to start trouble shooting your unit...and something that you can do rather then calling a repair person to do a simple thing for you...

Refrigerator Condenser Coil Cleaning Refrigerator Repair
http://www.fixya.com/support/r4024657-refrigerator_condenser_coil_cleaning

Refrigerator Troubleshooting Refrigerator Compressor
http://www.fixya.com/support/r3885294-refrigerator_troubleshooting

Refrigerator Compressor Start Capacitor and Start Relay
http://www.fixya.com/support/r4023749-refrigerator_compressor_start_capacitor

heatman101

I am assuming that it has run two consecutive cycles. I would first clean the machine inside and out. it should drop ice once cleaned, if not then open up the control box and find out which lights are flashing. I am almost certain that once it is cleaned it will drop ice.

See if you have 120 volts at the compressor if you do do you hear any clicking sound at compressor if not replace compressor Start Relay/Overload if you hear clicking sound the compressor may be bad or Start Relay/Overload the only way to know is to replace the compressor Start Relay/Overload. If you do not have 120 volts at the compressor jump out the thermostat you should have 120 volts at the compressor now if not you may have a defrost timer Prob. if this is shelf defrost unit check timer turn knob to see if it starts.

Sounds like your defrost timer has packed it in you need to fit another timer to it and everything will be as good as new.
by turning the timer you have forced it to run nothing to worry about. It has just stopped in the defrost position. What you have done is the first diagnostic test a tech would have performed. I hope this has helped you out.

Either your defrost timer, defrost heater or defrost thermostat has failed. All parts are located behind the lower back panel inside the freezer. Most likely are the defrost heater and defrost thermostat.

The switch turns on and off signal that lets you know that the freezer is to warm. One of the lights dose the same and the other is a power on light. All's well.