Whirlpool - Filled with water to wash and stopped. Pushed in and turned to see if I could get something to happen or reset the cycle. Does nothing at all.

Probably something hung up in water pump that still allows it to turn but rubs against impeller.

check drain hose maker sure hose not bent an check pump for trash in pump

your post is vauge

does it over flow
you mean it wont stop the rinse cycle


did you check it for a reset
do a factory reset

the machine will fill with water until the flow sensor and level has filled

so check and clean the machine

i find a couple of dishwasher cleaner tabs thru it first will clean all the flows and pipes and use a 60 deg long wash for whites
i think all the electro is aok so must be dirt

You would have to start the wash cycle all over in order to get enough water for the med load size. Once the washer starts it cycle you have to cancel that cycle to start a new one. Hope this is a help to your question

your drain line is probably plugged.remove it and clean it out.then start your cycle again.

sounds like the lid switch is faulty

It sounds as if the machine doesn't spin during the spin cycle. Normally the agitator stops spinning, fairly quickly, if the lid is opened during the spin cycle.That safety circuit includes a switch mounted under the opening and is set by a tab on the lid that protrudes thru a small hole in the top of the washer. The most likely failure on most Kenmore models is that switch, broken or loose, the tab on the lid broken, or the two misaligned. I would need the model number of your washer, located on a tag on the bottom of the lid to be more specific

YOU HAVE A BAD LID SWITCH

pump should be checked for restriction of movement,is there something blocking it?does the capacitor smell?if it does its blown(or meter check-more accurate),hope this helps

I would first check your lid switch I can tell you how if need be. Just e-mail me and let me know..