Can i purchase a replacement seal for around the

Unlikely there would be no air spilling through the door seal because it is an oven and not a watertight compartment. An oven door seal needs to be hard wearing and able to withstand high temperatures and hot grease which limits the materials used, that and the fact few domestic oven doors actually latch these days but are held closed by springs meaning the pressure against the seal is relatively light which means the door, the shut and the seal must be manufactured to a high degree of accuracy and properly adjusted.

If the amount or air leakage is excessive perhaps the door could be adjusted or the seal replaced. Try asking around to find someone with a similar oven so you can compare...

Why? Mine looks to be almost a "sealed" panel, similar to the sealed Thermopane for windows and Doors, only the outside surfaces can be cleaned. If there is a decorator cover, that can be removed via the surround and remove. But I'd leave it alone. Consider it's age, your age, when will you move or not move, when or if you will replace it, or remodel. If it's a critical issue, I'd look for a nice looking used replacement door.

the fault is unlikely to be the actual oven unit so therefore in order of least expense the things to check are:- the door seal being complete, the hinges not having been forced, the door not being buckled, self adhesive universal seals are available online from *spares etc. Hinges are easy to remove from the cooker and then can be unscrewed from the door and replaced. if it's the door I would have to say that's less likely to be available for a sensible price.

I believe this is the oven door seal. You can purchase this online from Ransomespares.co.uk product code RS46105 cost £29.25. Easy to fit, each rounded corner has little metal hooks which fit into the pre-drilled hole on the oven itself, simply unhook the old one and replace with the new, simple.

I trust the door is sealed correctly. If heat is escaping this could be the problem. If the seal is okay the only thing it could be is the oven thermostat controller. It sounds like it is faulty and needs replacing.

Cadco sells parts to the end use through a parts distributer. The phone number is 800 458 5593. Have your model and serial number ready when you call.

open the oven door and there are screws around the perimeter of the inner door cover remove these the seal then replace the glass and reverse the procedure make sure the heat seal gets put back right for the heat shield

It will be the oven element that has failed, a new one wiil need to be fitted.

It is located at the rear of the oven compartment behind a removeable cover.

I hope this helps.

I have a Zanussi ZDF290X which requires a new top oven seal. I have pulled the remainns of the old one out, but without dismantling the oven it seems impossible to fit the new seal. Any easy way of fixing this, please?

Mate try a anppliance store in your country, we have then here but shiping and time would take forever to ship it from here would take 2 months just regular mail.