Setting time and date on a rado multifuncton diastar ceramic

I bought watch from online website mirraw check it out here

http://www.mirraw.com/store/watches

hi the watch i found is pretty much identical. only thing is anchor is at different angle. points straight down not to the right and its a females watch. price is bout 506 pounds or 895 dollars. hope this is useful to u.

Just go to your local service center found on www.rado.com and they will replace the link for you for about $25.

Hi - I have a Rado Jubilee-Black Face-Lovely Dial
Problem:Time is set with a Key - Back of the watch
I have LOST this Key & need to buy or get one?
Can you please advise - [email protected]
Many Thanks
Ms>Mohamed

mcdevito75 here, Best Bet with your Rado watch, Look for a small watch repair shop in your area for adjustment / replacement.

That links are most likely ceramic! Take your watch to a reputable watch repair shop...they break very EASY! Make sure they know what they are doing!!!!

If it is a Hi-tech ceramic watch with multifunction display, then the market price should be around US 2,000.

Most likely, you have lost (or bent) a very tiny spring that is used to complete the circuit.

The piezo plate is bonded to the rear case; a part of the arm that retains the battery reaches up and contacts the rear case when the rear case is attached. The other half of the circuit, from the center-portion of the piezo crystal to the circuit board, is made via a tiny tiny tiny spring. (See a picture of a Casio contact spring doing the same job here.) In the Rado Multis that I have looked at, that spring rests loosely on a "pin" (and is therefore very easy to lose after the back is no longer holding it in place.)

Look for a cutout in the backplate of the watch mechanism, inside which is a gold pin or post that doesn't quite reach past the backplate. There's supposed to be a spring, resting loosely on this post, which (when the back is attached) reaches past the backplate to make contact with the center terminal area of the piezo.

If you're lucky, it's still in there, and bent or something. If it's missing entirely, you'll have to search out a replacement, or a watch repair that has them.

I bought the same watch recently and have the same problem. The hours can be adjusted in the dual time zone by looking up the manual, but the minutes stay put. I can't bring them to blink so that these could be adjusted. Any ideas? I sent a mail to Rado through their website but no answer.

Hears how i do my watch, i have the same watch as you.Just make sure nothing is displayed on the clock face by turning the winder, ie NO digital time, NO daul time, NO alarm, NO stop watch etc, Pull out the winder(crown) and adjust the hands to the time you require by spinning the winder.(Gentley for mins and fast for hours) The digital clock will display wilst doing this, but not change the time.handy if you want to sync both clocks.Push the winder back in at the time to sync and the digital display will go out, then spin the winder again if you want to display the digital features. I hope this helps, please post if it does, Maurice Chevalier- Herts