The analog hands of the watch are slower than the digital watch. Is there a way to synchronize?

If the analog part has been exposed to a magnetic field or very strong shock the hands may move some steps on. There should be a way to calibrate the analog part to its initial 12 o'clock position, from where the analog part will just catch up with the digital part.

On their web-site, you can find instructions for synchronizing the hands to the digital section. You'll need to load the instruction for the "module" of your watch, which is found on the back.

Hi,
You can try to so the synchronization to match the digital time and the analog hands.
here are the step by step procedure including visuals, click on the link.
I hope this will resolve your issue.
Thank you for choosing Fixya.

I could not get any result from entering your model in their web site but the "T Touch online" seems to be a watch that has similar features perhaps.

Their catalogues seem to be generic, so by going to their web site http://support.tissot.ch/?mod_flashPDF/id_138 you may finswhat you need.

I have read the instructions and theyare as clear as mud!

If you haven't already tried it, try foll0wing the "local time" setting instructions, with reference to the s#last section "If necessary perform setting..............." This should either alter the hands or the digital display, so that you can get them to agree.

If you still cannot set your watch, then you might find it useful to go to Tissot.com and click on "contact us" and send them an email explaining your problem.

Hi, activate the touch screen, touch the middle of the screen 3 times slowly until you see the OPT in the LCD. press the middle big button on the side of the watch once until you see the 24H screen, then hold down the same side middle button for 5 seconds, the display will then say SYNCRO.

You first move the hour hand with the top and bottom side buttons to 12 touch the middle of your screen to set then move the minute hand to 12 as straight as you can, then press the middle of the screen to set to exact digital time. Thanks Mark ;-)

The Tissot Touch watch is expected to need "SYNCHRONIZTION" periodically. (that is, to synchronize the digital and analog portions.) The Tissot manual tells how to do this. This manual came with your watch and is available online from the Tissot website.

good luck, Rodney

This is the tried and tested solution from this very nice gentleman. Many thanks to him (Ha Bi):

1. Press and hold on to the T button until it beeps
   
2. Touch the middle of the screen to change digital display to unit selection
3. Press and hold the T-button until "Synchronize" comes up in the digital display
4. Use the + button and - button to align the hour and minute hand to 12:00.
5. Click on the T-button again. Congrats, you're done!
6. Enjoy~

Must see blog for all T-touch users

http://myhabi.blogspot.com/2008/10/tissot-t-touch-battery-change.html

Here is complete manual for your watch:

http://www.t-touch.com/t-touch_images/usersmanual/140-en.pdf

If you are not successful with this, maybe it's time to change the battery?
Read manual carefully and you will find out how to recognize: I'ts time to change the battery.

Rate me, please.

They are supposed to move in unison, if you are setting the digital time and the analog is not moving, there is a problem with the watch and it could need service. Here is a link to the manual for the watch, the movement for the Blue Angels is a C300 and you will see the manual also states the time mechanisms move in tandem.
http://www.citizenwatch.jp/support/pdf/coa/c300.pdf

Citizen does have service centers all over the globe, I am sure you can get the watch fixed if it does need service, You can find the local service center at the Citizen web site. Hope that helps.