When I turn my Olympus FE-190 digital camera on,

the lens is faulty you must replace the lens.. you can find the lens on ebay international sellers.. if you have a little knowledge you can replace it alone find a lot of video with lens replacement on you tube german.. write this obiektiv umtausch so you can see videos with lens replacement
paolo sorry for my english

Take it to Best Buy for repair.

lens allienment /sensors of the lens failure,better contct olympus service

The problem you are describing is a problem with a sensor in the lens assembly. It seems to have failed and needs to be replaced. Following are the instructions to send your camera to Olympus for service.

http://olympusamerica.com/cpg_section/cpg_servicerepair.asp

Olympus will charge a flat rate repair fee for this product if beyond the one year factory warranty or the warranty is voided. The cost is $80.85 plus your local sales tax. This covers parts and labor, factory cleaning and diagnostic check, 6 month warranty and the cost of shipping the product back to you is all included in that price.

If the internal lens barrel gets knocked out of alignment it will cause that condition. If the camera senses that the lens is not in the proper position or not moving, it will turn back off rather than cause more damage. Pushing on the lens barrel to try to fix it will usually cause more problems than it already has. It has to be disassembled to be repaired.

at this point you may also want to check on your warranty status.

on the right side of the camera where the memory card goes in thats where it is usally loose it it does that. try not to touch the part that slides out when you take the pictures or turn it on and it will be back to normal.

I had this problem today, too.

No, I didn't get any responses.

best to check for the Olympus Website and download a manual of the said camera.

Hi,

There are no drivers needed for the Olympus FE-190. Once connected through its USB, the computer will treat it as a USB mass storage device similar to a removable /flash drive.

If for some reason the PC won't recognize the camera, it is probably a problem with the USB cord, the USB port or the memory of the camera.

Alternately, you can use a memory card reader and slip in the memory card of the camera to gain access to the content/pictures.

Hope this be of some help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.