Washer cuts off at 7 minutes and will not do the

Hey friend, thank you for your post!
I see that your Frigidaire washer, FWT449GFS2 is not entering the final high spin cycle. It is possible that you could have a defective motor or timer. Since it could be any one of these underlying issues I would recommend you having a professional come out to the home for the repair of your washer. -Matt

http://www.ehow.com/info_12127418_frigidaire-gltf2940fs1-not-spin-error-e59.html

If the unit does not spin correctly, this is usually an indication that the unit can also not drain. The unit will not spin if it senses a blockage or issue with the drain lines and/or pump. Try to check the drain lines in the back of the unit for any issue, and then see if you have an access panel to get to the coin trap or drain pump itself. Often socks and debris will clog up in this area and cause your problems.

It's the main control board that needs replacing. Here is a link to the part.

http://www.applianceblog.com/mainforums/frigidaire-electrolux/25178-fixed-gltf2940-washer-wont-spin.html this seems to be a common issue, here's the fix

I believe E47 is a door lock code.
You probably just need to replace the door latch.
Common problem with those units.

you will need to unplug the machine and take off the back panel and look for a small 5mm pipe leading upwards, take it off and blow gently into it you should hear a click and another one when you let the air out again if so then the small pipe where you took it from is blocked preventing the switch to work properly , unblock the pipe with a pipe cleaner or metal rod its normally full of soap goo return the pipe and close the back up and run the machine again eric

the most common cause is worn out brushes in the motor, sme brands you can rplace the brushes others require a new complete motor

Frigidaire front loader model # GLTF2940ES3.

Cycle ended prior to spin segment. Checked error code history to find E47 fault. Troubleshot per manual. Found that the "PTC one-spot check" read ~1582ohms. Although the book indicates that this is sufficient and recommends (rather tells) you to replace the control board we were still skeptical seeing as this is a ONE POINT check on a device that is non-linear. We went with the lesser of two evils. Purchased and replaced a new door lock. Works again! Phew, that could have been costly.