THROWS MACHINE OFF BALANCE EVERY TIME IT GOES INTO SPIN CYCLE REBALANCE MACHINE AFTER EACH TIME

The shocks have failed in it. It is an easily overlooked problem and causes all the issues you just said.

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_a67ead41eb5fc62a

Flashing letters are probably an error code. Check your owner's manual for troubleshooting. If still in warrantee, call the Customer service line. It's possible it does not like the out of balance load in the spin cycle. Try to rebalance and try the spin again. May take several tries to get the right balance.

could be a bad counter balance , u can remove the front panel and run a spin or wash cycle and listen to where its coming from so u don't have to replace all the balancers. on some models theres a heavy ceramic weight at bottom that at times goes bad and throws it off balance, just run it and look where noise is coming from

could be the springs are wearing out. some haier models I have seen start the spin at full motor speed, which could be part of the problem.

The stainless steel bowl has lost its ballast water & goes out of balance,Replace faulty bowl.

Your washer displays an estimate of time remaining in the current wash cycle. That estimate is based on the load finishing without any delays. Prior to going into a high speed spin, your washer "tests" the load balance by either rocking or slowing rotating.

If it senses and off balance condition, it will attempt to "rebalance" the load by itself and then retest, rebalance, etc. until it is satisfied that the load is as balanced as possible. Then it begins to spin. When your washer takes longer than is predicted in the display, it is because of this.

Happy washing...

Hi, UL means Unbalanced load in Whirlpool Cabrio....
UL is displayed when the machine/motor control detects an off-balance load, and is steady on while the washer runs a mini-cycle to rebalance the load. Display clears if mini-cycle successfully rebalanced the load. If the mini-cycle is unsuccessful, uL will flash until the door lid is opened, allowing the customer to view and redistribute the load....

Hi


Thanks for using FixYa. ULis displayed when the machine/motor control detects an off-balance load, and is steady on while the washer runs a mini-cycle to rebalance the load.
• Display clears if mini-cycle successfully rebalanced the load.
• If the mini-cycle is unsuccessful, uL will flash until the door lid is opened, allowing the customer to view and redistribute the load. Please do rate the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

uL is displayed when the machine/motor
control detects an off-balance load, and is
steady on while the washer runs a mini-cycle
to rebalance the load.
Display clears if mini-cycle successfully
rebalanced the load.
If the mini-cycle is unsuccessful, uL will
flash until the lid is opened, allowing the
customer to view and redistribute the load.
CHECK TO MAKE SURE IT IS LEVEL. LET ME KNOW IF I CAN ASSSIST YOU FUTHER. YOU MAY HAVE A BAD CONTROL BOARD.

Investigate the concrete block mountings. If they come loose, the balance goes way out