Error code f2 broiler comes on by itself and won't shut off

I would check the oven sensor it may be bad

Deb,
Here is a website that has some fault codes that might help you.


GE Fault Codes AppliancePartsPros com

Control board is bad.

Check the ribbon cable for connection

Follow the wires from the sensor to the control board and check the ohms there. It should be around 1050-1100 ohms, if the oven is at room temperature. If it is close to the correct ohms replace the control board. Probably a stuck relay on it.Here is the board to order.

All parts come with a 365 day, any part, any reason return policy.

The "F2" error code for this oven means "one or more keys on the keypad are shorted". The correction is to replace the control panel because keypad does not come separate.
The part is not available but if you call the number of that supplier I'm sure they may find the part for you.
Here is the info.

F2 Oven temperature too hot

Is your broiler element staying on?

your oven uses fboth the broiler element and the oven element during baking. Since you know the broiler element works, you most likely will have to replace the oven element.

The broiler won't turn off even when you press the "Off/cancel" button? It sounds like the broiler control relay is stuck shut. The F3 code means the oven temperature sensor has failed, this probably happened because the oven got too hot when the broiler was stuck on. There is fail-safe thermal fuse that will blow if the oven gets too hot, so the oven won't melt down but you should leave the unit off so you don't blow the fuse.

To fix the relay, you will have to replace the oven control module. I think this is about $200 and not too hard to replace if you are somewhat handy. The temperature sensor is also serviceable, you can find parts at Appliance Parts Pros on the web. Hopefully you haven't thrown the range out yet, let me know if you need further assistance.

Similar problem. When baking over 400 degrees we get the F2 code that can only be reset by cycling the power at the breaker. Replaced the electonics to no avail. I'm thinking its the cooling fan located between the oven and microwave (upper unit) it never comes on which may cause a separate temp switch to generate the F2... but I'm not a pro. :)