Kenmore Microwave Oven, Model#66568680891

Safety system locking out the start switch. Door not closed, mode and timer not set etc.

it has a fuse located behind the main control panel. you will see it after you remove the cover

You can set the clock to a 12 or 24 hour system.
For 12 hour - Touch clock pad once Enter the time using the number digits (1:00-12:59) Touch clock pad again
For 24 hour - Touch clock pad twice Enter the time using the number digits (0:00-23:59) Touch clock pad again

No, there is no possibilities to reset anything into a microwave oven.
Check the micro switches.

I have the same problem, diagnosed as bad touch screen panel.

Here are instructions on setting the time on the maison microwave sold by Aldi:- 1. Press the "clock" button 2. Press the "Cancel" button 3. Enter the time (at least 3 digits need to be entered) 4. Press the "clock" button again Hope this helps

try opening up the control panel,disconnect the connector ribbon coming from control panel and connected 2 control board by just pulling it out and cleaning end of connector ribbon and iserting it back.some times this works.if not then 4 sure touch panel needs to be replaced.

• Disconnect the power for 30 seconds. After restoring power, do not set the clock.
• If your model has an ON/OFF clock display, you can choose not to have the time displayed. To choose this option, press the 0 pad for about three seconds. To Turn the display back on, press the 0 again.

Touch the clock pad. Enter in the correct time of day by touching the numbers in sequence. Touch the clock pad again.

Quite often on the compact models, the solution is to pull the control panel assembly off, remove the circuit board and clean the surfaces shown in the photo with high-grade alcohol.

That would include the back of the LCD glass and both sides of the rubber strip.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

The 665 prefix on your model number is Whirlpool, but I haven't found the code "d" listed yet.

Can you set the cooking time?

If so, what happens when you press Start?

I'll post back if I find the codes or if you have other info and I can help further.