When i turn on my tv there is two red lines running from top to bottom one on each side of the tv one on the left about two inches from the side and one on the right about four inches from the side they both are about an 1 1/5 inches wide when it first started they would only be on for about 10 min when i first turned the tv on then they would go away now only the one on the right goes away and the one on the left will not they are transparent but they are predominant and i would like to get rid of them for good please help.
thanks is that some thing that you think i can fix my self? i am good with tools and i am a plumber mon-fri where can i order the pannels from?thanks is that some thing that you think i can fix my self? i am good with tools and i am a plumber mon-fri where can i order the pannels from?
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Try changing the input device to something you are sure works. Switch off TV manually, switch off power, remove plug and retry after 48 hours. If problem persists, please refer it to a qualified service technician.
Most like likely, this is a panel issue and it will be too cost to fix.
Other things you can try, reseating the ribbon cables on the buffer boards located running across either the top or bottom or both. If that doesn't do it, replace those boards and still no luck. Panel is bad.
Hello Depending how wide the line is their could be two possible causes.
I have two questions for you.
1. How wide is the line.
2. Does it run from top of screen to bottom of screen?
If the line is thin a single strait line then it is possible the PDP has gone Bad (Panel). (Screen). The screen will to be replaced.
If the line is at least 2 or more inches wide then its a buffer board which can be replaced. LG calls this board Hand insert Boards or display driver boards..
My set has encountered this magical 50/50 split screen and it seems to be quite a problem since I am not the only one researching this issue. LG was of no use because of course it is just out of warranty. Any solutions on fixing this or am I out of money in buying a new plasma?
either the address board or the panel has gone bad. the problem is that many times the address board is part of the panel. if it is under 2 years old you need to get with lg and push for a new panel
The vertical line, in my case, was due to a bad contact on the flexible printed circuit. I fixed the problem by using a piece of a rubber eraser to apply downward pressure on the flexible circuit as shown in the picture. To locate the faulty section lightly push on the flexible circuit from lef to right untill the line dissapears.
thanks is that some thing that you think i can fix my self? i am good with tools and i am a plumber mon-fri where can i order the pannels from?
×