How do I call forward this phone to my cell?

https://support.itel.com/hc/en-us/articles/202724885-Restore-an-Aastra-Phone-to-Factory-Defaults

Apparently not. I have the same problem and none of these answers really address your question.

Do you mean the feature light or the backlight for the display? The feature light can be set to on or off.

To set the light, press Save then 1 (for light on) or zero (light off). Press the desired memory key to associate with the feature and then enter the code from your telephone provider for that feature. Press Save and then label the memory key.

To use the feature light, press the memory key (as selected above) and then lift the handset. Press either Handsfree or Mute. The feature and the light will turn on or off. When the phone is not in use, then Feature On will be seen in the display.

The backlight is not adjustable. You can adjust the contrast with the Contrast button. Backlights do fail over time (but it's not a repair I recommend if the phone is out of warranty).

The manual is available here: http://www.aastratelecom.com/cps/rde/xchg/en-ca/hs.xsl/21564.htm . Look at the bottom of the center section for the PDF.

I hope this helps.

Cindy Wells

I suggest you consult the user manual.
You can get it in PDF format here : http://www.aastra.com/cps/rde/aareddownload?file_id=7959-13627-_MAS_XML&dsproject=aastra&mtype=pdf
Please rate if this answer helped.
Thank you!

In order to set call forwarding on this telephone, must first have the feature CFV (Call Forward Variable) on in the line. This feature can be provided by the telephone service provider.

A typical feature code for this is *72 to activate CFV and *73 to deactivate.

You can program these features on the M9316 telephone by do the following:

CFV activate

1) Press the SAVE key.
2) Then select the key where you want to program the feature.
3) Then enter *72 (optional: plus the telephone number of where you want the call to forward to).
4) Press SAVE twice.

CFV deactivate

1) Press the SAVE key
2) Then select another key where you want to program the feature.
3) Then enter *73
4) Press SAVE twice.

Be sure and label your buttons.

To use go off hook and press the key you just programmed.

If your phone company provides the service, you should have a code to enter. If YOUR telephone switch is doing the forwarding, you will also have a code to enter.

Basically, you enter the code, then dial the number and hang up. To unforward, you dial a similar code, and hang up the phone.

http://www.retrevo.com/d/ds/progress?doc=67ab324793d14f7027c630962ba726f8

Ok, this is your manual .I searched for "call forward" and this should help.

Just above the Hold button, with the Aastra name display, that is a sliding piece that will uncover your setup menu button. Press that and navigate to time/date settings.

Hope this was helpfull.

http://www.metacafe.com/watch/515782/how_to_dial_an_emergency_number_without_pressing_the_keypad_of_y/

I think forwarding is in your PBX rather than the phone.
On my system it is #1+ext to forward and #1 to cancel.