Oven pilot went out due to power outage. I don't know where the pilot oven light is. where is the pilot light to light the oven?Ge XL44

ck thermal coupling see if its to far from pilot light or burnt out

If you see the ignitor glowing down there that means power is getting to the oven circuit. You have a weak ignitor if that is the case. Sometimes you can bump it and make it work. Check out this video

Sillicone carbide ignitor operation

XL44 service manual



If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

you have a bad ignitor.even though it's glowing doesn't mean anything.it works with amps.3.2 amps opens the gas valve and then it ignites.

Hi,
Either you are out of propane or the regulator quit...
Check the tank and then replace the regulator...

heatman101

Make sure your oven timer is not set for automatic cooking

In general lets be clear. The OVEN pilot is located under the oven door at the top of the Broiler.It is a small piece of metal just before the GAS safety Valve which acts on temperature so gas won't flow unless Pilot is lit,That's the OVEN PILOT.The stove's RANGE is the top burners where you heat Pots and Pans.It has either 2 Pilot lights that connect the burners to the Flame they are under the Range Top.Newer Models use electronic ignitions no flame.Please note if you had your stove/oven disconected or Gas off when you turn it back on there will be air in the line that needs to escape before you light.This is why in NYC when Utility Co.works on steet main the MUST re-light your appliances.Be Careful with Gas.Good Luck.

Hi
On a GE range oven F7 indicates either a function pad button is stuck or the clock on the oven is malfunctioning

On the 99 Range oven F7 indicates a shorted Clear/Off Key due to membrane switch or a shorted control or connector

On the GE XL44 Self Clean Oven F7 is Stuck keypad or control relay malfunction
check out more detail here
http://www.fixya.com/howto/h155060-dreaded_f7_error
hope this helps

Hi

You don't say what type of GE oven this is so I will advise the following;

On a GE range oven F7 indicates either a function pad button is stuck or the clock on the oven is malfunctioning

On the 99 Range oven F7 indicates a shorted Clear/Off Key due to membrane switch or a shorted control or connector

On the GE XL44 Self Clean Oven F7 is Stuck keypad or control relay malfunction

Hope this helps. Please remember to rate my answer. Thank you.

hi thanks for the question just because the igniter lights up doesn't mean its good, the gas will not light, if igniter isn,t hot enough. and a very common problem is that the igniter does come on, but not hot enough to ignite the gas . replace the igniter thanks the appliance doc

I would try this first. It worked for me on a similar problem.

http://www.fixya.com/support/t120458-ge_profile_oven_ftp18_f7_code