all this is covered in the FSM. step by step. under body or doors.
2nd best is alldata.com
what door? you never said and steps can very by body options.
name the door,
i guess the latch is bad?
here are the words, for door lock motor.
lots of steps. my wild guess , it the door cover is off.
and the plastic film removed
and you get stuck here,
- Remove the tape covering the access hole on the carrier plate and discard. Access the window regulator liftplate through the hole in the carrier plate.
- Push down the door glass (1) and use a slotted screwdriver to release the tab on the window regulator liftplate (2). Lift the glass up and secure to the header.
- Remove the three screws (2) securing the door latch to the door shut face.
- Remove the one screw (1) attaching the latch bracket to the door shut face.
- Disconnect and remove the electrical connector (1) from the door (4).
- Remove the 10 screws (3) from the carrier plate (2).
- Disconnect the outside mirror electrical connector.
- Remove the carrier plate (2) from the door (4). end
once carrier is out there is chapter on that , disassebly
really, buy the FSM
or log in to alldata.com
and avoid making wrong moves, or getting hurt.
×