Sears Ken Elite upright freezer model no 25329082991 temp alarm

most all appliances are designed to be in an ambient not to exceed 80 degrees. Units will function but not up to design specs and would really strain to work. Only commercial unit can survive in temps up to 95 degrees in the Southeast U.S. and this temp varies depending on your general location.

On some models the beeping will not stop until it gets to normal temp. The -3 is more than likely the set temperature of the unit. you can try to change that with the control. The best thing to do is get a thermometer to check what the actual temperature is.

No. Sounds like the intern temp sensor is bad, missing, or not connected. 92 is probably the max reading it can display. The unit will probably operate continuously, be much to cold, and cost a ton to operate. I assume you bought this from Sears. Call them to replace the freezer. Should be no problem.

Try disconnecting power for about 30 seconds, and then restore power. This will reboot the control and maybe restart.

kenmore elite, alarm kept going on and b flashed on and off. I finaly figured out on bottom of freezer there is a battery door open it and change 9v. thats it,

kenmore elite, alarm kept going on and b flashed on and off. I finaly figured out on bottom of freezer there is a battery door open it and change 9v. thats it,

Faulty alarm.

if it can be turned off it will be in the kickplate but the alarm will go off when it gets back down to temp

Use a freezer thermometer and tell me the actual temperature. Or at least store some ice cream and see if it stays brick hard. Unless I have some idea of the actual temp I can't tell if defective freezer or alarm

is it possible the door has not been closed at some point?
If so they can build up with ice in the evaporator which the defrost system cannot handle....Try a manual defrost.
Depending on where the unit is installed high ambient temperature can drop the internal temp enough to set the alarm off though they will still freeze sufficiently