Check and replace damaged component/s at its horizontal scan output section circuit. Check the LOT (Line Output Transformer) too for damage. Replace the horizontal scan output transistor. Check the input voltage to LOT. If the voltage is absent check the feeder resistor; if any. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/ Type in this key phrase " my service table today " in the search box at the top right of the the home page, to get gathered some pages which has the details of practical experiences of the author of that site. The search result might display about 20 Nos of related posts. Press the "All posts" at the bottom of the list, then you can select them one by one.
SOURCE: TV Powered Off, won't come back on
mine did the same thing, I took it to a TV repair store and they said it was a power surge which damaged the power source board. (possibly caused by lightening)
total cost to repair was $70.00 well worth since was only couple years old.
TV is working well.------we'll see for how long????
SOURCE: I purchased a used Emerson TV Model 3 CR202EM8 and
go here if you cannot access the site: here are the instructions:
Your password will be erased and return to the default (0000) when a power failure occurs. If you forget the password, unplug the power cord for 10 seconds to restore
the password to 0000.
SOURCE: My emerson 20 inch flat
You should be okay just buying any generic universal remote. Any remote requires programming to work with a specific TV, but universal remotes are easily programmable. The instructions included with the universal remote will detail how you program that remote to work with your TV (usually along the lines of simply putting it in programming mode, and pressing the power button until it turns your TV off, and then locking it in)
SOURCE: Hi, I have an
This is a vertical deflection problem. If the picture shrinks suddenly after 20 minutes, then all that is needed is soldering the vertical deflection IC. If you can supply the model number, I can give you a location number in the set if you decide to fix it yourself. Otherwise, it can be fixed by a TV tech and the cost should be well under $100. If it needs the vertical IC replaced the cost of them is about $15 or a little less. Getting it shipped with other items that the tech needs for other sets should buffer the cost as shipping for it alone could run the cost to over $20. Also there is usually a 100 micro farad capacitor that needs to be changed along with the IC. But if you are lucky all you need is it to be soldered with no parts involved.
SOURCE: Emerson TV SN: 011-40401078 Model TC1379 The
Well somtimes buttons break off of tv's because that they are old so its not worth fixing an old tv
now a days most people just buy a new one then instead of fixing the old one. Or you could find someone that fixes old tv's too. To find an old tv like the phiilps one we used to have you would probally need to go to an antique store or and a pawn shop or a secondhand store or a garage sale then. Or the dump because sometimes people put things in the dump like CRT tv's to get rid of them then.
Your password will be erased and return to the default
(0000) when a power failure occurs. If you forget the
password, unplug the power cord for 10 seconds to restore
the password to 0000.
91 views
Usually answered in minutes!
×