Can I get a replacement door for my GE Profile Refrigerator

Inside the fridge behind bottom drawers there is a heat element that has stopped working.You will see it is covered with ice.you will need to replace it and totally defrost both and restart.

Most likely a thermistor


Stainless Steel ice box manual

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Is the compressor running?

clip on bottom of hinge is worn or broken had mine replaced. magnetic seals are not strong enough to hold the door closed on their own. Original problem was the magnets were too strong so the clip on the bottom hinge was added.

TAKE THE BACK PANEL OFF INSIDE THE FREEZER AND REMOVE ALL OF THE FROST WITH A HAIR DRYER. THE GLASS HEATEER AT THE BOTTOM OF THE ALUMINUM EVAPORATOR MAY NEED REPLACED. DEFROSTING THIS AREA WILL ALLLOW IT TO WORK FOR ANOTHER 10-14 DAYS.

The dispensor door not closing completely . Replace the flap solenoid and plunger behind the dispensor controls .

You can replace the doors but you will think you bought a new frig when you see what they cost. Most come as an assembly and are very expensive.
Eric

if you took out the door for the refrigerator to put in your house thats were your problem or gasket have to change

Can you give me the model number? Ther are alot of variation of handles.

I have a GE Profile Stainless Steel side by side. I also noticed that the refrigerator side door was not sealing like it had previously. There was no "suction" when opening. I started inspecting the gasket around the door to see if this needed replaced, as I had read that may be the problem from this forum. My particular model has the grill / vent at the bottom of the door, in the front, which just pops off. I found that down by the grill my model has magnets there that match up with magnets on the bottom of the doors. I inspected this and found a foreign object had attached itself to this magnet. I removed this object and waaahlaaah the door now has suction! I was relieved to find that I didn't need to replace the gasket. Worth a try. Hope this helps.