When I turn my camera on, the lense zooms out but nothing comes up on the screen..

On page 8 of the basic operate manual you see the backside of the camera and there you find the display button. Try pressing that one several times, while in recording mode.

has t\it got jammed..

Please make sure no cable is attached to the camera. On many Nikon cameras, connecting a cable shuts down the screen.

If the camera was on when it was dropped you probably jamed the lense coil. The lense coil is what helps the camera smoothly pull in the lense and back out. Now, just to specify, what exactly are you having a problem with? Will the actual lense not go back into the camera when you turn it off; or can you not get your camera off zoom?
Let me know~
Olivia

Hi,

you may have these symptoms,
Symptoms :

1. After pressing the power button in capture mode, the lens would extend and a slight humming from what appeared to be the auto focus motor could be heard for about 5 seconds. When the motor stopped humming, the camera would beep and display E:61:00 in the LCD Screen.
2. Camera would extend the lens but not be able to focus on anything past 8 inches or so.
3. Zoom in and zoom out would not work.
4. Playback mode and the Setup mode was not affected.

To fix this problem,


Do these...

A) Put the camera about a half inch from a hard surface.
B) Let the lense go out and hit the surface and retract a little bit. Let it go out all the way when it tries the next time.

If that doesnt fix it, try this:
A) Turn it on and let the lense go out fully
B) See where the lens comes out of the camera? The little round crack that surrounds it? Wiggle the lense a bit and blow in there a bit. (Be sure not to blow on the lense!)

Now turn it off/on again, and it should be fixed!


If not, try these steps a few more times. If still nothing, then I suggest you to call Sony, but this DID work for 90%, so hopefully it''ll work for you :)

Thanx for using fixya,
Cheers.

turn on when lense extends take hold of the end of the lense and gently twist and pull the lense you may hear it click do not force the lense then turn on and off again this should solve the problem.

Send it back in!

this usually happens when you turn on the camera with the lense cover still on. just turn it off and remove the lense cover and turn it back on again. hope this helps.

The only solution is to replace the lens module.that module is very costly. hope it help

It needs a service -contact the Fuji website technical support.