- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
you must test the power supply faulty a) by rizo , filter, diode, resistor. b) block from DAC, buffer, TRAnsistors, c) speakers some of them faulty or cracking. se the diagram attached
hi,
This problem will occur when any one of the driver transistor is become faulty. You have to replace all the driver transistor of the same channel which make cracking sound . It is very difficult to tell which one is faulty. Because if you check the transistors with multimeter it will be ok. Replace all the driver transistor in that channel with same part number marked on it. The driver transistors will look like this,
It may be of faulty Transistor. Here in your case the switching is not happening. Try to replace the transistor and power IC in the SMPS section. Check the transistor pin voltage to find out whether it is faulty. The Capacitor got bulged because of over voltage. The faulty component will be near by the bulged capacitor.
Usual problem is the Channel A amplifier has burned and blown the switching transistors. Usually an internal board arc occurs and unless very skilled at board work of clearing the burned area and replacing the components you are better to replace the HCA2400 amplifier module... about $160
If the horizontal transistor getting shorted, this could happen. Check the transistor 2 SD1398. If found faulty replace it. But replace black colored doides in the circuit as a whole. Leaky diodes can not be determined easily with the multi meter. Especialy the small high voltage diode near the small transformer connected to the 2 SD1368 transistor.
sir
i lose my mother board MSI 915 G Neo 2 Driver CD, Now i having land card problem if it possible please you send driver cd or solve my problem i waiting your reply
yours faithfully
dilawar
In case of a transistor which is faulty, could short the power supply in circuitry, and this happens after the transistor gets heated up. So you might wanna inspect the transistors on board to replace if found faulty.
Your described problem is as you suspected, the green is missing. This is a common failure and is technically an easy/quick repair. Almost always, the culprit would be a cold solder or a faulty color drive transistor/IC. They would be located on the small squarish PCB (printed circuit board) at the very rear of the tube. Of course, worst case scenario would be a faulty CRT (picture tube), but that would be least likely.
Corrective measure would then be initially re-soldering above describe solder joints and/or replacing faulty transistor/IC.
I think you both have faults on the line output stage of your tv either the line output transistor has become faulty or the line output transformer itself has become faulty. If you are able to check this for yourself otherwise find a competant technician. Hope this helps.
×