Simpson 700L Top loader washing machine won't spin anymore. It washes fine but when it gets to the spin cycle it wont spin. It drains ok. Any suggestions please?

I went google and typed in-- workshop manual for simpson espirit 450 top loader washing machine -- and got several pages one of which is www. manuals. club
I suspect that you may have to pay for the manual but on their page there is a listing for user manual, installation manual, service manual, parts list and schematics
try and see if you get what you want
there may be a loose connection to the program board or a faulty program board but I doubt that you will need a rewire or anything drastic like that

wont spin until it emptys check pump

My guess would be replace the pump, it is normally driven by the motor and if the wash cycle is good the motor is operational. You have to investigate to find the actual part to replace.

hi just read your posting.Does the machine spin and drain?Please reply with answer and I can help you further.

Hi just read your posting.After the 1st wash cycle the machine drains the water,Is the machine continuous draining?Or does the machine stop the draining and sit there silently?Please reply with additional information and I am sure I can help you.I have worked on this machine alot so if you reply back we can rectify the problem.Looking forward to your reply.

Hi just read your posting.Now does the washing tangle around the agitator?In your posting you mentioned the washing not distributing around the drum.Could you confirm that your machine is a top loader for me,because the word "drum and distribute" are terms for a front loader.If your machine is a top loader which I think it is then the problem could be your brake arm or spin coil is not operating.Please reply and let me know if the clothes are tangling around the agitator.Looking forward to your reply.

my simpson 550 wint spin, its stuck with a tub full of water and wont drain it. what should i do?

Bad/broken coupler/ http://www.davesrepair.com/DIYhelp/DIY285753.htm

Hi,
Try these steps

1. Test the lid switch
2. Test the timer control
3. Test the centrifugal switch
4. Test the water level switch
5. Inspect the motor coupler
6. Inspect the drive belt (belt drive only)
7. Inspect under the washer for soot (clutch)
8. Test the motor
9. Inspect the pulley
10. Test the transmission

pls rate my suggestion

i believe i can help you,,but washers dont agitate in the spin cycle,,i believe you ment it wont wring or spin in the spin cycle..your lid switch is defective,,replace,,if need be i can talk you though,,onthejob