Need help with Control Panel lights...some work, others don't. Trying to start wash, and when you press the Normal wash, it doesn't light up. The cancel light keeps coming on when "start" is pressed.
It seems as thought the "touch" sensors are bad..any suggestions??
cycle stops - no lights - press cancel drain its led blinks. -press any other key the rinse only light blinks.
About the only thing to try would be to remove the inner door panel to get to the control bd then you will see a mylar ribbon looks like a fat piece of scotch tape pull up on the plastic connector that holds it in and pull the ribbon out then get a clean pencil eraser and gently clean the ribbon and put it back in dont forget to push the locking tab back down then try it again and let me know
SOURCE: Kitchenaid Dishwasher Control Panel lights - some don't light up
control panel light all of a sudden do not come on and my unit wont start model kud101fl
SOURCE: ////////////////////my kitchenaid dishwasher lights are flashing
Can you explain the issue in detail - is your dishwasher not working at all, or the buttons continue to be lit up, etc?
First and foremost, check the dooe switch to see if it is functioning properly.
SOURCE: My normal cycle and cancel button lights are
Probably a keypad gone bad. Try replacing the keypad.
There is a troubleshooting guide behind the foot kick panel. It gives a sequence to test for a bad keypad. You can try that sequence to be sure.
SOURCE: the light on the buttons that say cancel and normal are flashing and the dishwasher won't turn on.
first thing to try is to disconnect power for 15 minutes and then try again if goes into default again take off bottom panel and behind the black trim will be a tech sheet see if it gives yousome diagonostics sounds like it may be the computer if the power off and on doesnt make it work,.
SOURCE: Kitchenaid dishwasher KUDPO2FRSS normal and cancel
Where is the filter on the Kithchenaid KUDPO2FR$$4 Dishwasher ?
Hello & Welcome to FixYa
Flashing
clean light is reset by pressing two buttons in sequence 3-4 times, to reset
your kenmore press these buttons in sequence:
High
temp wash-heated dry-high temp wash-heated dry
Please
get back to me if you have any other questions.
Kevin
1,547 views
Usually answered in minutes!
before receiving your response i arrived at the same cause - with the panel loose evrytime the cycle stopped and led's were blinking i touched the ribbon cable and the led's and washer acted normal. i will try the pencil eraser fix but it also could be a cold solder joint on the oin connector itself. the ribbon is terminated in a connector with female pins that mate to a male pin connector on board i will let u know.
water will not drain, control panel does not respond
×