Dishwasher cold rinse and low pressure

if it is the rear corner then you may have a leak in the drain line. take off the kick panel and see if you can tell where for sure it is leaking.

Propably you have leak from the main pump impeller seal.See the video below. It helped me to fix yesterday same problem.
http://www.youtube.com/watch?v=RLkMncM6JDE
If you open the bottom of the dishwasher you can see the leak.It leaves calcium at the base of the pump.

run it with no soap. if you get no leaks then cut back on your soap. you may need to run washer a few cycles to get rid of excess soap.

check the pipe leading from the dishwasher to the outlet, maybe under sink. this needs to be raise up as water will flow back into washer. Had this problem myself, felt foolish when the repair man just tied it up and left. !

Hi,

Here is a tip that I wrote about dishwashers and them leaking.

Leaking Dishwasher

heatman101

tg

It sounds like there may be an obstruction in the drain. once the washer is drained, in the bottom right corner there is a basket that you can pull up and clean out. As for the water pressure being low...The machine uses a pump that supplies the wash cycle, but on rinse it uses fresh water.You may have a pump that is clogged or losing pressure good luck hope this helps

Water is being forced out under the bottom door seal. Is the lower spray arm melted on the bottom? Or is there something directing the water flow toward the bottom of the tub instead of up toward the dishes?

ck the vac. brkr. on the back of the unit, if no vac. brkr. ck the air gap on the side of the mach. let me know how you make out.sounds like the leak occurs when mach. goes into the rinse cycle dont forget to vote thanks monomoy

does it leak when you don't use it? check around the fill valve.

Sorry about the delay in time in getting back to your problem if not already resolved heres what you can try. Remove the bottom panel and run through a load, to see exactly where leak is coming from, most common place for leak is through the heater hold down brass nuts. They crack and need to be replaced