Where to find meter readings on workmate m20i

Hi Dee,
Black and Decker Workmate 425 type 2 seems unavailabe
[only parts digarams] online but here's the instructions manual in pdf for Workmate 425 type 5 from
www.blackanddecker.com/power-tools/WM425.aspx

Hope this helps.Thanks!
Please vote this answer if helpful.

Go to "Reports" and then "Billing/counters". A print page with the counter.

Go to Xerox.com and under drivers and downloads for the M20i , download firmware version 3.02.
And follow the instructions to put the new software onto your printer.

There is no Workmate 350. Your model is the Workmate 125. See Black & Decker web site for manual Workmate 125

Release the lock, down the scanner is a tiny plastic piece between the oupt tray (the place where the paper goes out) and the top of the scanner
Fosg2000, Rate me please

I would first of all Go to the Xerox.com site and go to Drivers and downloads for the M20i and install the newest firmware. I believe the current version is 3.4.
I believe your problem would be resolved in loading the newest machine firmware.

You need to replace the fuser. There is a heating coil in the fuser roller that opens. Replace the fuser and it will resolve the problem.

You will need to do a couple of things, 1 remove, disassemble the scanner and thoroughly clean it, and while you have the scanner out, remove and clean the laser.
The toner cartridge may also be defective. that metering blade in that cartridge fails and causes light images also.
If you need instructions on how to remove and clean the scanner and laser let me know, I will type them out to you.
Not hard, just time consuming.
If you print out a report how does that look? If prints look fine and just the copies are light, then the mirrors in the scanner head a re probably fogged up. All the plastic in that scanner causes that same film on your scanner optics as you develop on your car windshield. Same process.

You have to pop the top cover off the cartridge and empty the new ink into it.
I doubt though that the metering blade that dispences the ink onto the roller will last another toner cartridge cycle. But good luck.