- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hello... may be you can set the desired temperature and later the remote control and/or the internal unit show to you the temperature of the air ... just let the air conditioning try to match your desired temperature...
Watch this...
https://www.youtube.com/watch?v=2Ck_xsdrmSM
If you have an automatic climate system where you can set temp the the compressor will run at some of the middle settings. The system blends cold and warm air to obtain the desired temp setting. If it does not have automatic control you have another issue.
on the remote control press mode button until u see the icon of the sun. then raise your temperature setting to the desired degree. there is a 3min delay from going from a/c, dehumidify to heat. temp will rise in the indoor unit. fan speed will be slow until it hits 90* across the evap coil then it will start ramping up in speed as temp rises.
need more info. will temp lower? if temp lowers try setting up to 104 if desired temp will not increase sounds like you need temp adjustment switch if desired temp goes up to 104 but water doesnt sounds like temp sensor if temp sensor is good heater element
the fridge will run until it reaches the temp. there should be a differential of 2 degrees so when the temp rises by 2 degrees the fridge should restart so you will need to make sure the differential is set to 2 degrees celcius on controller
the temp controller is bad in the fridge once it reaches cooling temp desired it cause the temp comtroller to go into a shut off mode due to being weak on the temp sensor tube
I own this remote. Here are the instructions.
1 turn on your tv or catv 2 aim remote at tv or catv 3 while holding tv or catv button press 0 to 9 last ch 100/ent or channel 4 release both buutons when tv or catv changes channel. note press tv or vcr or catv button first to select desired function
×