Hello , my oki b6200 display error replace fuser E. How to clear fuser counter.

Acci?n:
Encendido y espere hasta que la lista para imprimir el mensaje aparece en el panel del operador.
Pulse el bot?n "Seleccionar y el bot?n de flecha hacia abajo al mismo tiempo"
El men? siguiente aparece "Reiniciar contador del fusor U4"
Pulse el bot?n de flecha derecha
Panel del operador mostrar? "Fuser U4 Utilice el SEL para Reset"
Pulse el bot?n SELECT
Panel del operador leer? "Clearing"
Pulse la tecla Men? para volver al "Modo Listo para Imprimir"

hola como quito el error del panel de una oki b6200 me sale reemplaze fusor

The following procedure was provided by Oki Tech support when a web search did not provide an answer. Resetting the Fuser After Replacement - When Counter is NOT Reset First print out a MenuMap and note the fuser count, to later verify that the maintenance reset has taken affect. To reset the fuser counter, enter the diagnostics mode and go to Maintenance Mode Step-1 How to enter the maintenance mode. Hold the Menu & Right arrow button while powering on the printer. Hold the buttons down until the op panel displays “Initializing”. The op panel will display “Output Test” Step-2 Press the down arrow three times. The op panel will display “Maintenance Info” Step-3 Press the right arrow. The op panel will display “Reset Maint Reqd Execute” Step-4 Press the select button. A quick flash will come up on the op panel “Resetting Maintenance Reqd”. The op panel will then display “Reset Maint. Reqd. Execute” Step-5 Press the Cancel button to exit the Maintenance Mode and go back to “Online”. This completes the process, please print out the Menu and inspect the Fuser Count it should read ‘0.’

Reset Fuser counter Oki B6200 Action: Power on and wait until the ready to print message appears on the operator panel. Press "Select and the Down arrow button at the same time" The following Menu is displayed"Reset Counter Fuser U4" Press the right arrow button Operator Panel will display "Fuser U4 Use the SEL to Reset" Press the SELECT Button Operator Panel will read "Clearing" Press the Menu key to return to "Ready to Print Mode"

The laser went out. You have to have the ROS replacement kit. I priced it and it was $255 for it. They dont recommend doing it yourself. Its $75 an hr labor.

How did it get error? In the most case that error shows the time to replace another Fuser part.
The Fuser was ruined if you print over maximum number of pages (200,000 pages for eg.). If not the component of printer's Fuser is ruined, such as sensor, this is the most case that I have usually seen.

I think it's simple. But how to find it is a little difficult.

This error code is associated to the scanner unit, try cleaning it

Have you checked to see if there is any paper jammed in the sensor, at the back in the 150-sheet feeder assembly, if not the paper could be stuck the 150-sheet assembly

replase fuser
or
clear fuser counter

Don't Worry nothing is damaged.
The message usually shows when the electricity is off
it is easy! u just have to call to yr local service (Greece: +302310531334) and they will give u instructions to erase this message from the memory so as u can work again with yr oki.
THe instructions have to do with the menu on the oki display.