Question about Magic Chef CER3540 Electric Kitchen Range

1 Answer

Oven is not heating to set temp. - Magic Chef CER3540 Electric Kitchen Range

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 35 Answers

Replace thermostat

Posted on Jan 02, 2010

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bottom oven isn't heating to desired temp. Considering swapping the heating elements to see if one is faulty - thoughts?


try thermostat first. verify heating elements operational, if so check if tstats are same. swap if so, If not jump out tstat and see if higher temp achieved.

Sep 20, 2015 | Thermador PODC302 30" Double Electric Wall...

1 Answer

Oven heats up very slowly and does not reach the set temp


There is an oven temp gauge you can get to check the temp, When you have that you can remove the dial from the oven and if you look at the back you should see either one or two small screws. If you loosen them you can reajust the setting. Also if it (The oven) seems to heat up to slow It could be the heat sensor, That is in the oven and looks like a long rod. You can investagte changing that out but that is a bit more work.

Dec 02, 2014 | Amana Kitchen Ranges

1 Answer

Oven temp fluctuates


It is normal for the thermal device to turn on and off. Obtaining a steady temp is not always possible. When setting a temperature on some ovens, they have what is called a tolerance point. That means a set temperature has a range of a few degrees up or down. At the Down point, the oven is triggered to energize the coils and bring the interior of the oven back to the settings desired. The other factor is opening the oven and allowing cool air to enter, or in some cases a leaking door seal allows air to enter and heat to escape.

Feb 26, 2014 | Kenmore 30" Slide-In Electric Range...

1 Answer

Oven will not heat i set the temp , turn it on,


Hi

This means a loose/broken wire on the oven temp sensor or the oven temp. sensor itself is bad and should be replaced. To solve this issue test the oven temp. sensor, it should read between 1080-1120 ohms, if the rating is more then that and the door appears to be closing fine then it is the control board that is bad and should be replaced. Hope this helps...please post back for further assistance.
Daniel

Aug 31, 2011 | Bosch HGS 255 Gas Kitchen Range

1 Answer

Oven over heating , from set temp of 375 to over, third time the


Have you changed the oven sensor. If you have the problem is with the main oven control. Let's hope sensor for cost.

Feb 01, 2010 | Ovens

1 Answer

After temp is set bottom oven will not heat up to desired temp


you probably have a burnt out or shorted out lower bake element in you r lower oven. it sometimes will actually break apart or look like it sparked thru the black tubular section. it is common and will cause no heat during the bake cycle.
you could try to do a broil and see if it gets hot and that would let you know the control is ok and just needs the lower bake element.

Jan 28, 2009 | Maytag MER6772 Gemini Electric Kitchen...

1 Answer

Oven wont heat up to temp set


You will need to have the thermostat looked at or replaced, it may be defective and not reading the correct temp, also try using a manual oven thermometer to check the actual temp in the oven to give you a better idea of what the actual temp is inside

Jan 20, 2009 | Maytag 30" Built-In Single Electric Wall...

1 Answer

Temperature control


sounds like a bad bake ignitor(uneven heat,long cook times, long preheat times, perhaps even gas smell while cooking)

Sep 29, 2008 | GE Profile Spectra JGBP90 Gas Kitchen...

1 Answer

Oven light always on, no heat


probably the clock not set properly - you have the oven on automatic. switch off at mains, wait 5 mins and set the clock according to the manual. if the over-temp stat has operated, the oven goes dead

May 05, 2007 | Smeg S351X/5 Electric Single Oven

Not finding what you are looking for?
Magic Chef CER3540 Electric Kitchen Range Logo

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Magic Chef Kitchen Ranges Experts

Paul Carew

Level 3 Expert

3484 Answers

Marvin
Marvin

Level 3 Expert

85219 Answers

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Are you a Magic Chef Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...