What is the easiest way to get to the antenna in a 2000 Saturn SL1? I need to add an antenna extender for my satelite radio.

https://www.google.com/search?q=Need+to+no+where+mass+air+sensor+located+on+a+2002+cavalier+2.2+motor&biw=1363&bih=650&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwidypiQ58LQAhXJ7iYKHevTAvsQsAQIHQ#tbm=isch&q=Does+anyone+have+the+color+codes+for+the+2001+Saturn+SL1+radio+harness%3F

Hope this helps

You need this tool to pressure test the cooling system.

normally done with radio keys fit into slots and radio pops out
radio shack or your local dealer will have them

check fuses if fuse is good the stereo is bad

That is your low coolant level light. Add antifreeze/water mixture to the overflow resevoir

my 2000 saturn sl blows cold air with the heater on. I changed the thermostat,and checked out my heater core.Still blows cold air.

Hello,

The best possible thing I could advise you to do would be this. Sometimes they can do it over the phone. Tell them that you are having issues with your radio being locked. Usually they can look up by your VIN number and get you your unlock code. Otherwise you will have to take it to the dealer and have them hook up their vehicle scanner (Tech-2) and they will be able to fix it. Everyone on the internet has their own secret ways about how to obtain these codes, but with it comes to GM the best way is to take it to a dealer.

Good Luck!

Visit http://www.radio-code.com/index.htm

Good luck.

The procedure to replace the radio is given below:
1.On both the right and left sides of the black housing that goes around the radio and air controls, there is a circle with another circle inside of it, push in the middle circle, this will release the clips, remove those.
2. the three buttons on top of this piece can be disconnected from it by squeezing the clips underneath.
3. remove plastic shroud.
4. there should be two bolts at the near the top, remove these.
5. slide radio out, disconnect clip, and antennae.
6. done

Sound like two different problems,Check crank sensor for dying issue.Also check ecm fuse it underhood juntion block.and injector fuse.