Any help with a Canon Pixma MP 250 P2 Error Code?

On my Canon MP 240 the P2 error code was because the belt which drives the cartridge unit had slipped off, so the motor turns but the cartridge unit doesnt move. Just make sure the belt is fitting over the cog correctly. As you look into the printer from the front - the cog is on the left hand side. This took away the P2 error code message on the lcd.

I think you need to reinstall printer driver again, Be sure unistall by REVO then reistall the drivers again.


Download the printer drivers from this link Pixma MP950 Driver download
http://printer-driver-download.us/canon-pixma-mp-950-driver-download/

printernya udah absober, cara memperbaikinya bagaimana ?

This could be because the ink cartridges may be empty or been replaced with compatible types.
Solution:
You could try to do a reset by pressing and holding the reset button (red triangle) for 5 seconds. If that does not clear the error then try pressing and holding both reset and maintenance (pliers and screwdriver picture) for over 5 seconds. The flashing error code should change to normal counting display digit 1, and the scanner become usable.

Hello
This error is wasted ink full reset the printer press reset button and hold then press on relase and press twice reset button is now in maintenance mode to reset wasted pad ink press 4 times the reset button then turn the printer button on/off
Hope it helps, good luck

bagaimana cara memperbaiki printer canon MP 258 Eror 5200 P08

Printer is in use or an error has occurrred. check status. Scanner driver will be closed.

Canon error e27 ink absorber full/reset process

printer powered off but connected on power source , you must:
1. Press & hold stop/reset button, and then press & hold [ON/OFF] button.
2. When Green power lit, leave stop/reset button & press twice stop/reset (see orange indicator).
3. Leave On/Off button. Printer in actually service mode.
4. Press stop/reset 4 times (see orange indicator) if not blink restart above process from top.
5. After press stop/reset 4 times successful press On/Off button 3 times. printer will off.
6. Press On/Off button.

reinstall ur printer driver

Go here to get a free printer