Lcd screen flickers in photo mode

Hi,
Your camera must be experiencing these symptoms due to a faulty CCD, and not due to other problems. If the problem is due to your dropping the camera, you might be out of luck.
If you have not dropped your camera and still facing this problem, then contact service people to replace the CCD imager in your camera .

Hope this helps .
Shane

the lcd screen liquid may leak out or damaged. you need change or fix it
www.skiliwah.cn/
http://www.digitalcamera-parts.net/
e-mail:[email protected]

This sounds like it might be a defective CCD imager. If so, Canon should fix this for you for free, including free shipping both ways. This is regardless of your camera's warranty status. Please check this link for more info.
Applicable cameras include:
A40, A60, A70, A75, A80, A85, A95, A300, A310, S1 IS, S60, S200, S230, S330, S400, S410, S500, SD100, SD110, IXUS V2/V3/300/400/430/500/II/IIs, IXY Digital 200a/300a/320/400/450/500/30/30a

It is known problem of bad ccd imager in Sony DSC-T1 camera and ccd imager chip will be replaced to get normal live view in camera mode.
Sony will repair it free of cost so click Sony CCD Imager Support for details.
Thanks.

Maybe the display was turned OFF. Check it and turn it ON. If still in problems, look for a specialized service to check you camera.

Hi!
Have you tried pushing the button first under the mode dial? It changes view mode, just above the MENU button?

Tom

U ARE LUCKY !

it is CCD PROBLEM
thousands facing the same see the link but the best part is u can get it repaired free of Cost bcoz it is a manufacturing fault

see the link

http://esupport.sony.com/US/perl/news-item.pl?mdl=DSCT1&news_id=161

Pls rate me FIXYA for help

This is normal for this camera. Think about it. The CMOS chip can't see through the mirror. After the shot is taken the electronic shutter exposes the CMOS chip and makes an image just like exposing film on a film type camera. Once you get used to it you may like it better. In outdoor or bright light situations it's difficult to view the LCD screen to frame the shot anyway.

Your camera works just like a film camera SLR,. You use the eyepiece to frame and focus your picture. The LCD screen is for reviewing pictures taken or menu operations. You cannot preview a shot on screen before it is taken with the camera.

This is a button/firmware problem Canon Customer support will advise on your next move -depending on the age of the camera