Will not start washing process

Needs a new belt.

There is sometimes a pause between wash and spin. This allows a little time to pump the water out before starting to spin. Do you hear the pump running between wash and spin?

The to ensure that the water valves at the inlets are fully open. If they are, then shut them off and remove the hoses from the supply to the washer. There is usually a small metal screen-type filter in the connection at the back of the washer for each hose. These may be clogging up. They can be carefully removed, cleaned, and reinstalled.

Amazon.com: Customer Reviews: Speed Queen 3.3 Cu. Ft ...

www.amazon.com/Speed-Queen...Washer/.../B004ZO...

Amazon.com, Inc.Find helpful customer reviews and review ratings for Speed Queen 3.3 Cu. ... If you need more water in the tub you can hold down the reset switch until the machine ... I tried the delicate wash and spin cycle, but the clothes retain too much water and ..... It takes time to correlate the number of turns and the direction to turn it.Missing: overspeed

Commercial Washer and Dryer Problems

www.affordablelaundry.com/commercial-washer-and-dryer-problems

The water should shut off once it reaches wash level, if it doesn't, and water level hasn't... (these are the glass type fuses) be sure to turn power off before checking them. ... If you have the voltage in, but not out, it's the contactor. .... We repair: Speed Queenwasher, IPSO washer, Milnor washer, UniMac washing machines.Missing: overspeed

[PDF]View document in PDF

speed queen double front load washer spinning without stop,please give some idea,thanks alot

Make sure that the lid switch is working as it can make the program from advancing forward. So check the continuity of the switch that goes to trigger the main board.
If Ok then the program controller is not functioning, if you can try to change manually then the control board is faulty.

check hoses and pump area.

Hi, just fixed the daughters speed queen, same problem. The three brake shoes were worn allowing the tub to spin with the agitator.
replaced the shoes, washer fine. At first I thought it was the top ring. spent 30 dollars for nothing.
good luck

Have you removed the front panel?

If not remove front panel two screws 5/16 on bottom

Start the washer in a cycle. look with a flash lite and look for leak.

It maybe the rubber boot.

Please let me know if you have any other questions.

I will also need model number, because a AWS52NW is a top loader model number not a front loader.

T