DI-624 Need help setting up my DI-624

hope this helps

Go to http://www.dlink.com/corporate/worldwideoffices/?redirect=%2fdefault.aspx for your driver.

Thanks for your interest in FixYa.com

You don't need a driver for router to set it up. You need to connect it with a cable to your computer, log into administration module with browser . Download D-Link browser toolbar from http://toolbar.aol.com/dlink/download.html
This will help you administer you router.
Do not forget to set wireless security.

First press reset button for 10 seconds it is in back side of router.
Then connect router to computer with ethernet cable then you can access it with following link.
http://192.168.1.1
or
http://192.168.0.1
type user as "admin" and password as "admin" or blank or "password"
then you can see configuration page.
Enable DHCP if you want to get ip from router for your LAN.
Go to wireless enable it .
Then enable wi fi security wep security then enter WEP key it is your password to connect internet .
Then save settings and restart router.
Let me know if you need more assistance.
Thanks.

There are multiple revisions of the DI-624, each with version specific drivers, firmware, installation guides, and other resources. Please use the descriptions below to identify your revision.
The links will take you to the drivers and install guides.

Note: The revision is located on the label on the bottom of the device next to H/W

The DI-624 Rev. A has 2 antennas.
<img src=http://support.dlink.com/prod_img/revisions/DI-624v.jpg>

Driver here: http://support.dlink.com/products/view.asp?productid=DI-624

The DI-624 Rev. B has 2 antennas.
<img src=http://support.dlink.com/prod_img/revisions/DI-624_revBv.jpg>

Driver here: http://support.dlink.com/products/view.asp?productid=DI%2D624%5FrevB

The DI-624 Rev. C has only 1 antenna.
<img src=http://support.dlink.com/prod_img/revisions/DI-624_revCv.jpg>

Driver here: http://support.dlink.com/products/view.asp?productid=DI-624_revC

Check this link:

http://support.dlink.com/products/view.asp?productid=DI%2D624%5FrevE

Yes, you can connect the DI-624 to your exitsing EBR-2310, you just need to connect the a cable from port 4 of the EBR-2310 to the internet/wan port of the DI-624, then after that you can already use now the wireless to your laptop and also the wired router to your desktops.
But I may suggest you to just replace the EBR-2310 with the DI-624 so you will only be using 1 router that can cater your laptop and also your desktop, Just connect the cable from your modem that is conencted now to your EBR-2310 to the internet/wan port of the DI-624 then run the setup CD that should be it.

Hope that helps...........

You don't need any software, no. All you need to do is login to the router (usually 192.168.2.1 or 192.168.1.1 for D-link) and configure the wireless security (including the key)).

try a cross cable between di-624 and westell dsl router.

The WAN settings should be configured by Verizon personnel only. If you reset the VDI-604 or VDI-624 to factory defaults, you will need to contact Verizon to reconfigure your WAN settings.