I need a service manual for a Dayton oil fired 350,000 BTU heater.

check motor /pump working or needs reset

Dayton 3E134E Troubleshooting guide - manualzz.com

manualzz.com/doc/1285710/dayton-3e134e-troubleshooting-guide

This heater must be installed and serviced by trained gas installation and service ... Dayton High-Intensity Heaters ® Description Dayton high-intensity heaters ... ofinfrared radiation by heating a ceramic refractory material to incandescence. ..... 3E133, 3E461, 5VD63, 5VD64 90,000 BTU/H Do not mount heater horizontally.

[PDF]Fall Heating - Plumbing & HVAC

plumbingandhvac.ca/images/documents/PHVAC_Sept-Oct03.pdf

Nova Scotia gas utility eyes dealer network ... valve underbody and screw trim pieces ... Infrared requires a different way of ... gives you a crisp picture, and speeds up pipe locating. ... tiative will keep HVAC contractors busy ..... labelling for equipment usinghigh pressure R410A ..... Multi fired from 90,000 to 179,000 btu/h.

Try with this site:


SERVICEMANUALS @ COST www.mauritron.com Manuals at free download: homeappliance.manualsonline.com/manuals/.../lg_air_conditioner_product_list.html

Hi,

Here are a couple of tips that I wrote that tell you how to troubleshoot a Torpedo or Reddy heater...

Reddy Heater - Troubleshooting Torpedo Heaters

Torpedo Heater Pump Pressure Adjustment

heatman101

./././././././././././././././././

Sounds like you have a bolwer motor or fuel pump that has bad bearings, as it runs, it starts to bind up, and get to the point where it is pulling to much juice to turn it, and the fuse does it's job and blows?
If you could give be a bit more detail, I can help you furthur.
Please rate the new guy :)
And get back to me, so we can get the problem fixed for you.
Lets get this fixed.
Sincerely,
Paul Gibson

http://www.bealsmotor.com/

This web site has been a great help for all my Dayton heater parts. They have all the parts straight from the owners manual with prices. It shows the picture of all the parts just like the owners manual and how they all go together. Good Luck!

Look up Grainger or WW Grainger on the web they should be able to help you find the part.

Most use a spark plug to ignite fuel it could need cleaning. You also could have water in fuel or dirt
check and clean ignitor/spark plug clean fuel line and nozzle, drain and clean tank Check for water in fuel by tilting unit to have a low corner siphon fuel from that corner after 1 hr inspect for water.

You write "FUEL SPRAYING AND FAN WAS WORKING"

If the fan was working, but the fan is not working now after replacing the whole kit, then something was installed incorrectly during the installation, possibly the rotor gap or rotor thickness is not correct or vane/vanes installed 90 degrees off.

throw a gas can in a fire it is alot more fun.call the manufact